Tstudy TD-801 Dot Matrix Digital Pen User Manual
- June 6, 2024
- Tstudy
Table of Contents
Tstudy TD-801 Dot Matrix Digital Pen
Dot-matrix digital pen
TD801
Press the Dot matrix pen power button or press the induction pen tip, the
pointer end indicator lights up, and the Dot matrix pen enters the power on
state. If the indicator light does not go on or the yellow light flashes,
please charge the D ot matrix pen first.
After the battery is fully charged (about 2 hours), it will be turned on for
use.
Specification
Weight| 24.5g| Dimension| 154.211.211.2
（mm）
---|---|---|---
Input| 3.7V / 250mAH
by battery
| Standby
Time
| 50days
Charging
Time
| <2Hours| Working
Time
| >6 Hours
Wireless| BT 4.2| Transmission| 15meters
| | distance|
---|---|---|---
Dimension of Pen Refill| 67.2mm*2.3mm| System| Windows7 and above
Indicator state
| Display | State |
|---|
constantly
light
| Waiting for BT connecting or finishing charging
constantly
blue
| Connecting
flash yellow| Low power wanning
constantly
yellow
| Charging
constantly red| abnormal state
constantly red| Memory full
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.