ifollower 989-222 2.4GHz Amphibious Stunt RC Car Instruction Manual

ifollower 989-222 2.4GHz Amphibious Stunt RC Car

Warning:

1. Please read this instruction manual carefully before installing & operating this car.
2. Children aged under 3 need adults’ supervision while playing.

when the light15 nashing .
How can I know If the signalpairing15 successful or not?| ln dlcalor fight on there mote controller will flash when It Is 5Witchedon.and then It wlll be turned off once paired successully after your car r.s turned on,
The car run sslowly| 1.    Replace or fully recharge the battery

2.    Check if the cars geared properly or the  arsaredirty

The car doesn’t work

| 1.    Make sure all 5wltc:hes are turned on

2.    Check If all batteries ate full y powered.(lncludlng the batteries of there motecontroller and the ear)

3.    Cheek If there are damages of the car or remote controller

The car only turns and cannot move forward or backward

| 1. Recharge the battery of the car or replace the batteril!-Sof the remote controller.

2. Push the upward or downward button to check lf the Indicator light flashes.

3. Re•pa.lr the signal by re-switching them on.

4. Check If the motor is damaged.

The car only move forward or backward cannot turn.| 1.Check If the car or remotecontroller Is damaged.

Battery information

• INPUT: 5V 2A
• OUTPUT: 3.7V 0.5A
• Battery: 1 x 7.4V 500mAh lithium ion
• Rechargeable Battery Pack
• Requires: 1 x 7.4V 500mAh lithium ion
• Rechargeable Battery Pack
• Battery requirement for controller:
• Batteries: 2x 1.5V AA
• Requires 2×1.5V AA size batteries (not included).

The Waste Electrical and Electronic Equipment Directive (WEEE Directive) is the European community directive on waste electrical and electronic equipment, which became European law in February 2003. The main purpose of this directive is toprevent electronic waste. Recycling and other forms of waste recovery should be encouraged to reduce waste. The symbol (trash can) on the product and on the packing means that used electrical and electronic products should not be disposed

Package Contents

How to charge the car

1. Full recharge the battery with the USB charging cable provided.
2. Insert the rechargeable battery into the car case.
3.  Close the battery cover tightly.

How to install batteries into the remote

1. 1.Release A button by a sharp objects to slide down thecover B.
2. Install two AA batteries as shown.
3. Push up the cover to lock the remote.

of with general household waste. It is your responsibility to dispose of all your electronic or electrical waste at designated collection points. Disposing of thisproduct correctly will help to savevaluable resources and it is a significant contribution to protect our environment as well as human health. For moreinformation about the correct disposal of electrical and electronic equipment, recycling and collection points please contact your localauthorities, waste management companies, your retailer or the manufacturer of this device. Batteries are marked with the symbol of a crossed out bin. This symbol indicates that empty batteries or accumulators which can no longer be charged should not be disposed of with household waste. Waste batteries may contain harmfulsubstances that can cause damage to health and to the environment. Please use the return and collection systems available in your country for the disposal of thewaste batteries

FCC

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction

How to connect the controller

1. Turn on the car, the light inside the car will be flashing.
2. Press the red button to turn on the remote, the red light will be stably on.
3. Start your fun by operating the controller.

Note:

1.  Please make sure your car is full recharged and the controller battery is installed.
2.  Red button on – remote on / signal paired.

• Red button flashing – signal pair failure
• Red button off – remote off / battery ran out.

Operation Direction

Troubleshooting

After-Sales Service

• www.myifollower.com
• service@myifollower.com (for US CA)
• serviceeu@myifollower.com (for DE FRITES UK)

EVATOULTING LTD Suite 11,First Floor, Moy Road Business CentreTaffs Well, Cardiff, Wales, CF15 7QR

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>