Chug 212WGH01 Wireless Gaming Headset User Manual
- June 5, 2024
- Chug
Table of Contents
Chug 212
WGH01 Wireless Gaming Headset
**User Manual
**
212WGH01 Wireless Gaming Headset
-
Mute Button
Short Press to mute Mic or not. -
ON/OFF
Hold this button to power on/off. The headset will be automatically be paired to the dongle. To power on hold for 3 seconds. To enter pairing hold for 5 seconds. -
Volume Roll
Upward: V+ Downward: V -
Type-C charging point
-
LED
Red LED when charging, LED off when charging full.
Pairing: Blue LED blinks quickly
Paired: Blue light will be constant when paired
Unpaired: Blue LED blinks every 1S -
Aux-in Port
Wireless Gaming Headset
PS4
- Plug the 2.4Ghz receiver into the USB port located on the front of your console.
- The headset will be automatically be paired to the dongle. To power on hold for 3 seconds
- Enter the settings menu > Devices > Audio Devices. · Set input and output device to USB Headset
- Change “Audio Output to Headphones” to “Chat Audio”.
- Set headphone volume level to your desired setting. Select the microphone level and follow the prompts to adjust your desired settings.
Xbox
- Plug in the provided 3.5mm AUX cable into the headset and controller.
PC
- Plug the 2.4Ghz receiver into an audio-enabled USB port on your PC.
- The headset will automatically be paired to the dongle. To power on hold for 3 seconds.
- Set audio input and output to a USB-connected device.
- If you are having trouble in a game make sure that in your sound control settings on your PC that your USB device is selected for default communications
Nintendo Switch
- Use in wired mode
Model: 212WGH01C
Input: 5V 400mA
MADE IN CHINA
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science, and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Chug Inc., 7157 Shady Oak Road,
Eden Prairie, MN 55344 USA
Phone/Téléphone: 888-778-5401