Numark DJ2GO2 Touch 2-Channel Serato DJ Controller User Manual

: June 5, 2024
: Numark

Table of Contents

Numark DJ2GO2 Touch 2-Channel Serato DJ
Box Contents
Operation
Important Safety Instructions
NOTICE CONCERNING FCC REGULATIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Numark DJ2GO2 Touch 2-Channel Serato DJ

Controller

Box Contents

DJ2GO2 Touch
Mini-USB Cable
Software Download Card
1/8”-to-stereo-RCA Cable

Quickstart Guide

Before you can begin using DJ2GO2 Touch with your computer, you must install a DJ software application on your computer.

With a DJ software application installed on your computer, connect DJ2GO2 Touch to an available USB port on your computer. (If possible, use a USB port on the rear panel of your computer.)
On your computer, open your DJ software application.
Once the software opens, search for your music, video, and/or karaoke files.
Once a supported file is found, load the file to one of the software decks.
Repeat the process to assign a file to the other software deck.

Operation

Pad Mode Controls

Cues: This Pad Mode button switches between Hot Cue Mode.
Auto Loop: This Pad Mode button switches Buttons 1-4 to trigger loops (loop bar value is set in your software).
Pad 1 – 1 beat
Pad 2 – 2 beats
Pad 3 – 4 beats
Pad 4 – 8 beats
Manual Loop: This Pad Mode button switches Buttons 1-4 to manually control looping. In Manual Loop mode:
Pad 1 – Loop In Set Point
Pad 2 – Loop Out Set Point
Pad 3 – Loop On/Off
Pad 4 – Retrigger Loop
Sampler: This Pad Mode button switches Buttons 1-4 to Sampler Mode to trigger samples.

For the complete multilingual User Guide, visit

ESD/EFT Warning

This unit may contain a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lock up. In the unlikely event that this should happen, turn off the unit, wait at least five seconds, and then turn it back on again. The pins of connectors identified with this ESD warning symbol should not be touched. For best audio quality, avoid using this device in a high RF-radiated environment. In an environment with radio frequency interference, the unit may malfunction and resume normal operation after removal of the interference.

Correct Disposal of This Product

This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling

General Note on the Declaration of Conformity

We hereby declare that this device is in accordance with the essential requirements of the European Directive 2014/53/EU or 2014/30/EU (LVD: 2014/35/EU; GPSD: 2001/95/EC). The full EU declaration of conformity can be requested at the address shown here or at numark.com/safety

nMusic GmbH Harkortstr. 12 – 32 40880 Ratingen GERMANY

Important Safety Instructions

Read and keep these instructions. Heed all warnings and follow all Instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not place exposed flame sources such as lighted candles on the apparatus.
Only use attachment/ accessories specified by the manufacturer.
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
Power Sources: This product should be connected to a power supply only of the type described in these operating instructions, or as marked on the unit.
Water and Moisture: This product should be kept away from direct contact with liquids. The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus.
This apparatus is for professional use only. Intended operational climate: tropical, moderate.
Warning: Excessive sound pressure (high volumes) from headphones can cause hearing loss.
Warning: Please refer to any important information (e.g., electrical, safety, etc.) printed on the exterior bottom enclosure or rear panel before installing or operating the product.

Safety Notices

WARNING: To reduce the risk of fire or electrical shock, do not expose this appliance to rain or moisture. Electrical equipment should NEVER be kept or stored in damp environments

NOTICE CONCERNING FCC REGULATIONS

You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (a) reorient or relocate the receiving antenna; (b) move this unit; (c) increase the separation between the equipment and receiver; (d) connect the equipment into an outlet on a circuit different from that to which the receiver is connected; (e) be sure that all cables are properly shielded, using a choke or ferrite where appropriate; or (f) consult the dealer or an experienced radio/television technician for help. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC RF Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter

For Canadian models

This device complies with Industry Canada licenceexempt RSSs. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
This radio transmitter (identify the device by certification number, or model number if Category II) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.
This unit does not exceed the Class B limits for radio noise emission from digital apparatus set out in the radio interference regulations of the Canadian Department of Communications.

World Headquarters inMusic Brands, Inc. 200 Scenic View Drive Cumberland, RI 02864

USA