SYNCHRO TRIMIX-RF06 Remote Controller User Manual
- June 5, 2024
- SYNCHRO
Table of Contents
SYNCHRO TRIMIX-RF06 Remote Controller User Manual
ELECTRONICS OVERVIEW
PAIRING THE WIRELESS REMOTE
STEP 1:
Push in on bottom of remote to release battery cartridge and install three AAA
batteries into the remote battery compartment.Push in firmly to close.
STEP 2:
Plug the base into a power source and press the Pairing Button/Program Button
on the control box approximately in ls,ensure the Pairing Lamp – White (Third)
flashing.
STEP 3:
-
Press “SW” until the backlight LED flashing ,release it and then press “HEAD UP” ,never release until the backlight LED is lighting all Iong,the remote is pairing and release it.
-
When the Pairing Button/Program Button on the control box and the backlight LED on the remote stop flashing, and the buzzer on the control box has a “DI” sound,pairing is completed.
-
If the function on the remote can not be operated,repeat the pairing again.
FUNCTIONAL OPERATING FOR WIRELESS REMOTE
Product interface description
The interface in the red box below are only used for engineering testing and are not open to consumers.
FCC/ISEDC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment . This transmitter must not be colocated or operating
in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>