Lanparte LRC-01 Remote Control for Sony Cameras Instructions
- June 5, 2024
- LanParte
Table of Contents
INSTRUCTION
Power On
Long press photograph button for 2 Seconds, selfie stick starts to search device with flash blue light, blue light off once connected. Turn on the phone camera and press photograph button, blue light flashes once to start taking picture.
Power Off
Long press photograph button for 3 Seconds, blue light flashes 3 times to turn off. Automatically turn off when selfie stick disconnected to Bluetooth over 180 Seconds.
Sleep Mode
Once connected devices with Bluetooth, no operating over 600 Seconds to enter sleep mode, long press photograph button for 2 Seconds to activate.
Photographing
Press photograph button to take a picture. During sleep mode, long press photograph button for 2 Seconds to awaken the Bluetooth.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment