ZEEVA ET-0011 Gesture Control Battle Robot Instruction Manual

ET-0011 Gesture Control Battle Robot

Instruction Manual

Thank you for purchasing the Gesture Control Battle Robot. This manual provides more information about this product,
please read the instructions before using.

Product Overview

Gesture Control Battle Robot Power On/Off

Power On/Off
Slide the ON/OFF Switch to ON to turn on the Gesture Control Battle Robot.
Slide the ON/OFF Switch to OFF to turn off the Gesture Control Battle Robot.

Package Contents

Gesture Control Battle Robot x 1
Gesture Remote Control x 1
Instruction Manual x 1

Specifications

Gesture Control Battle Robot Power Supply:
4 x “AAA” 1.5V Batteries
(Alkaline type preferred, not included)
Gesture Remote Control Power Supply:
3 x “AAA” 1.5V Batteries
(Alkaline type preferred, not included)
Frequency: 49.86MHz

Gesture Remote Control On/Off

Power On/Off
Slide the ON/OFF Switch to ON to turn on the Gesture Remote Control.
Slide the ON/OFF Switch to OFF to turn off the Gesture Remote Control.

Operate Your Robot

Note: To avoid losing control, always pay attention when playing the
Gesture Control Battle Robot.

Right Punch

Hold the right Gesture
Remote Control and punch

Left Punch

Hold the left Gesture
Remote Control and punch

How To Play

Back of the insert card
Follow the dashed line
to cut out the “Target
Practice” board & “Do
Not Pass” block.

Operate Gesture Control
Battle Robot to hit the “Target Practice” board
to count the score You can also create more
“Target Practice” board by yourself

Battle with other Gesture Control Battle Robot and
avoid crossing the “Do Not Pass” block

*Other Gesture Control Battle Robot sold separately

Batteries Installation-Car

To install batteries into the Gesture Control Battle Robot, unscrew the
screw on the battery box cover to open the battery compartment. Insert 4 x
“AAA” 1.5V batteries (Not Included) into the battery box. Batteries should
be placed as shown in the diagram.
Put back in place the battery box cover and tighten the screw.

Notice:
When placing the batteries, you must insert according to the correct
polarity, the Gesture Control Battle Robot won’t function if batteries are
reversed.

Batteries Installation-Remote Control

To install batteries into the Gesture Remote Control, unscrew the screw on
the battery box cover to open the battery compartment. Insert 3 x “AAA”
1.5V batteries (Not Included) into the battery box. Batteries should be
placed as shown on the diagram.
Put back in place the battery box cover and tighten the screw.

Notice:
When placing the batteries, you must insert according to the correct
polarity, the Gesture Remote Control won’t function if batteries are
reversed.

Performance Tips

1. Do not control the Gesture Control Battle Robot on grass, sand or go through water.
2. Do not control the Gesture Control Battle Robot in windy or rainy weather.
3. Do not control the Gesture Control Battle Robot into any sharp object.
4. Keep fingers, hair and loose clothing away from Gesture Control Battle Robot.

Care and Maintenance

Always use dry and soft cloth to clean this product.
Avoid this product from being exposed to sunlight or heat.
Avoid immersing these toys in water, otherwise, the electronic parts may
be damaged.
Check the product regularly. If any damages are discovered, please stop
using immediately, until it is completely repaired in good working
condition.

IMPORTANT: BATTERY INFORMATION

CAUTION:

1. TO AVOID BATTERY LEAKAGE
a. Always follow the instructions carefully. Use only batteries specified and
be sure to insert them correctly by matching the + and – polarity markings.
b. Do not mix old batteries and new batteries or standard (carbon-zinc) with
alkaline batteries.
c. Remove exhausted or dead batteries from the product.
d. Remove batteries if product is not to be played with for a long time.
e. Do not short-circuit the supply terminals.
2. Should this product cause, or be affected by local electrical interference,
move it away from other electrical equipment. Reset (switching ON & OFF
again or removing and re-inserting batteries) if necessary

Warning

This product is suitable to be used by people who has operating
experience in remote toy or aged no less than 8 years old.
Please do not put the product in your mouth to prevent choking hazard of
small parts.
Please do not put the finger into available interspaces.
Please do not play the product in a brutal way such as throwing, crashing
or twisting it.
Please store the smaller-sized product accessories in places that are out
of reach of children, in order to avoid the occurrence of accidents.
Avoid placing the batteries in places in high temperatures and avoid
exposure to heat.
When young children are operating the product, it shall be ensured that
the adults are guiding and making sure the product control is within the
viewing range of the controller (or instructor) so that it makes the control
of the toy more convenient.
When the product is not in use, please switch off the power supplies of
the toy, and remove the batteries from the product.
Please note that we won’t take any responsibility for any wrong operation
as this may result in severe injury or loss of property, and we cannot
control the operating process during the time when the user assembles or
uses this product.
Once this product is sold, we won’t be responsible for any safety
responsibility during the time the user operates or uses controls this
products.

FCC Statement

This device complies with the part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Caution: changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with instructions may
cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on. The user is
encouraged to try to correct the interference by one or more of the
following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or experienced radio/ TV technician for help.

RF warning statement:
The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure
condition without restriction.

GREEN ROBOT FCC ID: 2ADM5-ET-0011-49

Item# ET-0011

Keep All Relevant Information for Future Reference

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>