Zhejiang Tri Mix Technology TRIMIX-RF04 Remote Controller User Manual
- June 5, 2024
- Zhejiang Tri Mix Technology
Table of Contents
Zhejiang Tri-Mix Technology TRIMIX-RF04 Remote Controller
Instructions
ELECTRONICS OVERVIEW
PAIRING THE WIRELESS REMOTE
STEP 1：
Push in on the bottom of the remote to release the battery cartridge and
install three AAA batteries into the remote battery compartment. Push in
firmly to close.
STEP 2：
Plug the base into a power source and press the Pairing Button/Program
Button on the control box approximately in 1s, ensuring the Pairing Lamp –
White (Third) flashing.
STEP 3：
Press “SW” until the backlight LED flashing, release it and then press “HEAD
UP” , never release until the backlight LED is lighting all long,the remote is
pairing and releasing it.
- When the Pairing Button/Program Button on the control box and the backlight LED on the remote stop flashing, and the buzzer on the control box has a “DI” sound, pairing is completed.
- If the function on the remote can not be operated, repeat the pairing again.
FUNCTIONAL OPERATING FOR WIRELESS REMOTE
| MARK | STEP1 | STEP2 | FUNCTION | DESCRIPTIONS |
|---|
| ****
Press “SW” in 3s until the backlight LED flashing and then press the “BUTTON” in STEP 2
| ****
TV
| ****
MEMORY POSITON
| ****
The backlight LEDs all OFF before operating.
l Press（TV,ZG,M）until the backlight LED is lighting and the memory position is completed.
l When the backlight LED is lighting and press again, clear the corresponding memory position.
l TV & ZG have the memory position ,M no memory position.
ZG
M
ANTISNORE
| ****
New ANTI-SNORE preset position and five minutes will be reset.
BACK UP
| ****
PAIRING
| ****
Pairing the remote and control box.
FCC/ISEDC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
This device may not cause harmful interference, and this device must accept
any interference received, including interference that may cause undesired
operation. Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment. This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co‐located or operating
in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>