SIGMA SIG560023 BC 5.0 WR Cycling Computer Wired Instruction Manual

: June 5, 2024
: SIGMA

BC 5.0 WR
BC 5.0 WL
INSTRUCTION MANUAL

SP 1

VIDEOS & FURTHER INFORMATION

https://goto.sigmasport.com/bc50/service

FIRST START
Press 5 sec.

Battery already installed

INSTALLATION

INSTALLATION MOUNT

|
---|---

INSTALLATION OF WIRED SPEED SENSOR

INSTALLATION OF WIRELESS SPEED TRANSMITTER

Emission frequency: 112 kHz, Max power < 11.37 dBm

TECHNICAL DATA

Computer WIRED:
– Battery type: CR 2032, 3V
– Battery life: 3 years (When used for 1 hour per day)

Computer WIRELESS:
– Battery type: CR 2032, 3V
– Battery life: 2 years (When used for 1 hour per day)

Transmitter:
– Battery type: CR 2032, 3V
– Battery life: 1.5 years (When used for 1 hour per day)

LEGAL STATEMENTS

FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT

Caution: If any changes or modiﬁ cations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
The grantee is not responsible for any changes or modiﬁ cations not expressly approved by the party responsible for compliance. Such modiﬁ cations could void the user’s authority to operate the equipment.

The RF Exposure Compliance distance is 5 millimeters.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

− Reorient or relocate the receiving antenna.
− Increase the separation between the equipment and receiver.
− Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
− Consult the dealer or an experienced radio/TV technician for help.

FCC ID ATS2021: M5LATS2021

INDUSTRY CANADA STATEMENT

This device complies with Innovation, Science, and Economic Development Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:

(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.

CAN ICES-3(B)/NMB-3(B)
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with a minimum distance of 5 millimeters between the radiator and your body.

UKCA STATEMENT

Wireless Model

We, SIGMA-ELEKTRO GmbH, declare that the equipment above has been tested in our facility and found in compliance with the requirement limits of applicable standards, in accordance with the Radio Equipment Regulations 2017 and the Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012. The test record, data evaluation, and Equipment Under Test (EUT) conﬁ gurations represented herein are true and accurate under the standards herein speciﬁ ed.
Wired Model
We, SIGMA-ELEKTRO GmbH, declare that the equipment above has been tested in our facility and found in compliance with the requirement limits of applicable standards, in accordance with the Electromagnetic Compatibility Regulations 2016 and the Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012. The test record, data evaluation, and Equipment Under Test (EUT) conﬁ gurations represented herein are true and accurate under the standards herein speciﬁ ed.
EU-DECLARATION OF CONFORMITY
We, SIGMA-ELEKTRO GmbH, Dr.-Julius-Leber-Str. 15, D-67433 Neustadt/Weinstraße declares under our responsibility that the product BC 5.0 WR is compliant with the essential requirements of the EMC Directive 2014/30/EU and the RoHS Directive 2011/65/EU. The declaration of conformity can be found at: ce.sigmasport.com/bc50wr
CE INFORMATION

You can ﬁ nd the CE declaration at:
ce.sigmasport.com/bc50wr
ce.sigmasport.com/bc50wl

BUTTON OVERVIEW

FUNCTIONS / SETTINGS

ICON OVERVIEW

: trip distance
: trip time
: total distance
: clock

EXAMPLE OF SETTING PROCEDURE:

Open settings: Press and hold S button >3 sec. until settings open.
Choose the relevant page: Press M button until the desired value is displayed.
Open submenu: Press 1x S button.
Change value: Press M button until the desired value is displayed.
Conﬁ rm chosen value: Press 1x S button.
Note: Do steps No. 4 and No. 5 until the submenu is closed „Set Ok“.
You are now back in the Settings Menu.
Close settings: Press and hold S button >3 sec.