Asterisk ASR-L70D Dongle RFID Reader User Manual
- June 5, 2024
- Asterisk
Table of Contents
Manual: Dongle RFID Reader
Model Name: ASR-L70D
Project Name: AsLock LF RFID Reader
Revision: R00
Supplier Approval
| Made by | Checked by | Approved by |
|---|---|---|
| jsyi |
Customer Approval
| Checked by | Checked by | Approved by |
|---|---|---|
Smart Power Solutions, Inc.
| Products | Dongle RFID Reader | Reversion | A 101 |
|---|---|---|---|
| Document No | Manual -ASR-L7OD | Released | 2020-06-18 |
| Created By | Jinsung Yi | Revised By | |
| Page | 2/8 page | Revision Date |
Revision History
| Rev | ECN | Description | Approved by |
|---|---|---|---|
| R00 | Initial draft | ||
Overview
Introduction
Asrock LF RFID reader complies with RFID standard – ISO 11784/11785, FDX-B.
It can communicate with the host through a USB-C connector.
It is powered by a Li-ion battery (700mAh).
It can be charged with Magconn.
Product Appearance
Case Materials: PC (PolyCarbonate)
Charging: Magconn
Button: 2 buttons
Hardware Specifications
Charging
The device can be charged with a Magconn cable.
Charging time: 2 hours
Host interface
The device can be connected to the host by AsLock Locker ™
Operation
Device Driver and COM Port
OS Requirement: Windows 10
No device driver is required in Windows 10
- Connect AsLocker to AsLock RFID Reader.
- Connect type C cable to AsLocker and connect another side of type c cable to PC.
- Connecting to PC will turn the AsLock RFID Reader powered on.
- Ignore IAP Interface.
- Make sure that COM[N] is recognized by Windows 10.
GUI SW
After launching SW, you can see the screen below.
- Click “Open” to comport
- Click “RFID On” to turn on the RFID module
- Click “Start” to read an RFID tag.
FCC Information to User
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution
Modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
FCC Compliance Information: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC ID: 2AJXE-ASR-L70D
Product Description
| DEVICE TYPE | A,)Lock RFID |
|---|---|
| OPERATING FREQUENCY | 134.20 kHz |
| RATED RF OUTPUT POWER | 72.9 dB u\ in |
| ANTENNA TYPE | Coil Antenna |
| MODULATION | ASK |
| RATED SUPPLY VOLTAGE | DC 5 0I( |
SQP-0621(Rev.0)
Smart Power Solutions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>