CGPTC20B PTC Heater User Manual
- June 15, 2024
- CG
Table of Contents
CGPTC20B PTC Heater
Product Information
PTC Heater
Read this manual carefully before operation Pictures in this manual are for
reference only, the product in kind prevails.
Model : CGPTC20B
This instruction manual contains important information & recommendations that
we would ask you to comply With to obtain the best results from your products.
INTRODUCTION
- Before using your new heater, please carefully read through the following instructions. KEEP THIS BOOKLET IN A SAFE PLACE SO THAT YOU MAY CONSULT IT LATER.
- After removing the packaging, make sure that the appliance is in good condition.
- The packaging materials may contain plastic, nails, etc., which may be hazardous and therefore should not be left within the reach of children.
IMPORTANT SAFETY INFORMATION
- Check whether or not the local power supply mains match the appliance electric rating printed on the label before operation.
- Children should be supervised to ensure that they do not play with the appliance.
- If the appliance is damaged, do not use it anymore.
- Ensure the power supply to the socket into which the heater is plugged is by the rating label on the heater.
- When the appliance is not in operation, please remove the plug from the supply mains.
- The plug must be removed from the socket outlet before cleaning or maintaining the appliance
- Don’t remove the plug by pulling the power cord.
- Avoid the use of an extension cord as this may overheat and cause a risk of fire.
- Keep the mains lead away from the hot body of the heater.
- WARNING: To avoid overheating, do not cover the heater.
- Don’t use this heater in the immediate surroundings of a bath, a shower, or a swimming pool. Never locate the heater where it may fall into the bathtub or other water container.
- The device is intended for household use. Do not use outdoors.
- Do not cover or obstruct any of the heat outlet grilles or the air intake openings of the heater.
- Always ensure that the heater is not positioned close to curtains or furniture as this could create a fire hazard.
- The heater must not be located immediately below an electrical socket outlet.
- Do not insert any object through the heat outlet or air intake grilles of the heater.
- Do not place this heater near flammable materials, surfaces, or substances, as there may be a risk of fire.
- Particular care should be taken when the heater is situated in areas occupied by children or invalids.
- Always unplug the heater when moving it.
- The room that is to be heated should not contain any easily inflammable materials (e.g., petrol, solvents, spray canisters, etc.) or other easily combustible materials (e.g., wood or paper). Keep such materials away from equipment. Risk of fire!!
- Do not operate the heater with a damaged cord or plug, or after the heater malfunctions, has been dropped, or is damaged in any manner.
- If the supply cord is damaged, it must be replaced by the manufacturer its service agent, or a similarly qualified person to avoid a hazard.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance
FEATURES
- Adjustable Thermostat Switch
- Heating Power Switch
- Oscillation Switch
- Handle
OPERATION
- Before inserting the plug into an electrical outlet, make sure that the electrical supply in your area matches that on the rating label on the unit.
- Carefully remove the heater from the plastic bag and the carton.
- Place the heater on a firm-level surface
- Set the adjustable thermostat switch to”-“. plug the cord set into a 220-240V~ 50-60Hz, AC source.
- First of all, turn on the Adjustable thermostat switch and then turn on 2or3 or both in warm wind, only turn on 2and3 are hot wind. If you don’t turn it on 2or3, the appliance will blow natural wind
- Set the rotary switch to the maximum for a fast warm-up of a room.
- Once The room is comfortable, select a lower setting to reduce electrical consumption and prevent the room from becoming too warm. Adjust the thermostat to maximum and select the desired power setting.
- Once the room is comfortable, rotate the thermostat counterclockwise, until the heater shuts off. The thermostat will now maintain the temperature by cycling the heater on or off.
- During particularly cold weather, the low power setting may be insufficient to satisfy the thermostat. Select a higher setting for these periods.
- Before switching off and better to work for 5-10 seconds in cool conditions.
- Adjust the thermostat to maximum and select the desired power setting.
- Once the room is comfortable, rotate the thermostat counterclockwise, until the heater shuts off. The thermostat will now maintain the temperature by cycling the heater on or off.
- During particularly cold weather, the low power setting may be insufficient to satisfy the thermostat. Select a higher setting for these periods.
- Before switching off, wait for 5-10 seconds in cool condition.
SAFETY TIP-OVER SWITCH
The appliance has a safety tip-over switch for safe protection. Make the user
away from fire and other damage.
OVERHEAT PROTECTION
This heater is protected with an overheat protection that switches off the
appliance automatically in case of overheating. For example: due to the total
or partial obstruction of the vents. In this case, unplug the appliance, wait
about 30 minutes for it to cool, and remove the object which is obstructing
the vents. Then switch it back on as described above. The appliance should now
operate normally. If the problem persists, please contact Customer Service for
assistance.
CLEANING & MAINTENANCE
- Before undertaking any cleaning or maintenance on the appliance, disconnect it from the power supply.
- For cleaning it is recommended to use a soft moist rag and neutral detergent. Do not use an abrasive cloth or devices which could affect the appearance of the appliance.
- Check that the hot air outlet and the ventilation inlet are free of dust and dirt. During cleaning, be careful not to touch the heating elements.
- To open the filter on the back for cleaning, press the top of the plastic net at the back.
- In case of breakdown and/or poor functioning of the appliance, disconnect the appliance from the power supply and contact an authorized repairer.
SPECIFICATIONS
- Power Supply : AC 220-240V ~ 50-60Hz
- Power Consumption : 2000W
NOTE : As a result of continual improvements, the design and specifications of the product may differ slightly from the unit illustrated on the packaging.
Environment
Meaning of the crossed-out wheeled dustbin:
Do not dispose of electrical appliances as unsorted municipal waste, use
separate collection facilities. Contact your local council for information
regarding the collection systems available. If electrical appliances are
disposed of in landfills or dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging your health and well-being.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH
EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must not be disposed of as urban
waste. It must be taken to a special local authority differentiated waste
collection centre or a dealer providing this service. Disposing of a household
appliance separately avoids possible negative consequences for the environment
and health deriving from inappropriate disposal and enables the constituent
materials to be recovered to obtain significant savings in energy and
resources. As a reminder of the need to dispose of household appliances
separately, the product is marked with a crossedoutwheeled dustbin.
Visit us at : www.cginspiringlife.com
inspiring life SINCE 1982
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>