NQD 757-C337 Gesture Remote Control Car Instruction Manual

NQD 757-C337 Gesture Remote Control Car

REMOTE LAYOUT

(The watch remote control is used with one cr202-5 button cell) button Cell is a non-rechargeable battery if the power rubs out

Watch Sensor Control

1. Fist rises vertically, body twist rises
2. The fist goes down vertically, body twist is reduced
3. Fist eaned forward. the car forward
4. Fist eaned back. the car backed
5. Fist eaned Left. the car drifted Ieft I rotated counters  clockwise see in p I ace
6. Fist leaned right. the car drifted right / rotated clockwise  in place
7. Short press the finger button to switch modes (horizontal run / rotate),  long press to mute

An automatic pairing frequency

1. installs the batteries in the remote control. and the remote control Indicator wi 11 start flash. Then install the battery in their car and turn on the switch to start the connection. When the connection is successful. the remote control indicator goes off. (Please repeat the above operation if tne connection fails)
2. Each remote control can only be connected to one car. When the connection is successful, each car wi 11 not interfere with each other. (Oo does not connect multiple cards at the same time)
3. If the remote control does not detect the 2. 4G signal from the remote control car after one minute. the power indicator flashes. you must restart the power switch to pair the frequency.
4. When you need to pair with other models of remote control or remote control car. you need to turn off the power of the remote control and remote control car to repair

PRECAUTIONS

The battery charger using this toy must be checked regularly to prevent damage to the wires and other parts. If it is damaged, it must be used after the damage is repaired

Watch Sensor Control Demo

The fist rises vertically. body twist rises

Fi st goes down vertically twist is reduced

Fist leaned forward, the car forward

Fist leaned back, the car back

Fist leaned left, the car drifted left/rotated counterclockwise in place

Fist  eaned rt right, the car drifted right / rotated clockwise in place

Battery Installation Instructions

The remote control uses two 1. SV (AA) non-rechargeable batteries Please install the batteries correctly according to the polarity instructions. (Battery is not included)

Battery socket to body Power socket

Charging Instructions

1. To protect the performance of the battery pack, do not charge the battery pack immediately after use. Leave tho battery pack for a few minutes before recharging.
2. The US8 charger indicator is on during charging. and the indicator is on during charging, The charging time is about 2-3 hours,
3. It is normal for the battery pack to generate slight heat during charging

RC Car Operation Instructions

1. Turn on the remote control car switch
2. Operate the remote control’s arrow key’s to control the direction of the car
3. Turn off the remote control car switch after use
4. One-click deformation. When the deformation key’s pressed, the car wi11 automatically deform
5. If the remote control car does not receive a command for one minute, it will enter the semi-sleep state (the semi-sleep state is not equal to shut down, only the power consumption is reduced). and the lights and sounds are turned off. After entering the semi-sleep state, you can wake up by anyone ion of the remote control
6. if the remote control is not connected to the remote car for one minute it will be automatically entering the sleep state you can wake up with any button
   Note: The battery has Low voltage protection It will automatically power off when the voltage is low, and it can be activated after charging.

Battery Precautions

1. This product uses ono 3. 7V rechargeable battery pack. The remote control uses two 1. 5V “M” non-rechargeable batteries.
2. The battery should be taken out and installed correctly according to the polarity and voltage s igns on the toy battery box, and the battery should not be short-circuited.
3. Non-rechargeable batt&r ies cannot be charged.
4. The recharaeable battery must be charged under adult supervision.
5. The rechargeable battery should be removed from the toy before charging,
6. different types of batter ies or old and new batteries cannot be mixed
7. Only use the same or equivalent batter les as the recommended ones.
8. The exhausted battery should be removed from the toy, If not used for a Long time please remove the battery from the toy.
9. The power terminals should not be shorted.
10. Do not connect to more than the recommended nt.rrber of power sources.
    During the use of the toy USB cable, it shou ld be regularly inspected for damage to its wires. plugs, cas ings and other components. When damage is found, it should be stopped unti I repaired

General Troubleshooting

General Troubleshooting|
---|---
Ma I function

Condit io n

| | Cause of

Ma  function

| how to deal with

Car DooM’t Work

| The remote control is not connected or the switch of the remote control car is not turned on.

The remote control or remote control car  is  not   properly   installed   the battery,

The rechargeable I e battery pack has insufficient power.

| 1.    Turn on the remote control   car swi tch and reconnect  the remote control I,

2.    Install  the     battery into the

remote control or remote

control cat correctly.

3.   Charge the rechargeable battery pack.

l..uncontrolled Car Near Remote Control Distance

|

1.    The battery in the remote control

or rechargeable battery pack is low.

2.    There may be interference sources near the site.

|

I. Replace the batteries •n the remote control with new batteries or charge the rechargeable battery pac k.

2 . Change the site .

Maintenance Matter

1. Do not stay near the source of the tire, avoid direct sun1ght, high temperature, and humidity or keep it, in the car for a long time to avoid short Circuits and fire
2. Take Out the batteries of the remote control car and remote control when not playing. and put the remote control and remote control car back in the color box to avoid damage Or deformation during transportation or storage
3. The remote control car must be gently wiped with a damp cloth.

FCC Warning Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits tor a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. this equipment does cause harmful interterence to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interterence that may cause undesired operation.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>