AKEKIO BH01 Wireless Headphones User Manual
- June 5, 2024
- AKEKIO
Table of Contents
AKEKIO BH01 Wireless Headphones
Candy Bila BH01 Wireless Headphones
- 1x Candy Bila BH01 Wireless Headphones
- 1 x 3.5mm Audio Cable
- 1x USB Type-c Cable
- 1x User Manual
Product Diagram
BH01
On /Off
- To power on the headphones, press and hold the MFB button for 2 seconds. The LED indicator will flash blue for 2 seconds.
- To power off, press and hold the MFB button for 4 seconds. The LED indicator will flash red for 2 seconds and then go off.
Bluetooth Pairing
- Press and hold the MFB button for 5 seconds until the LED indicator flashes blue. A moment later, the headphones wll automatically enter pairing mode, with the LED flashing red and blue alternately.
- Activate the Bluetooth function on your Bluetooth-enabled device. Select the CB-BHO1 from the list of Bluetooth devices found by your device and connect.
Mode Switch Button
- Short press the mode switch button for light on or off.
- Long press 2S the mode switch button to switch between Bluetooth and TF mode.
Operation of Buttons
| Volume Up | Short press the “+” button. |
|---|---|
| Volume Down | Short press the”-” button. |
| Next Track | Press and hold the “+” button for 2 seconds. |
| Previous Track | Press and hold the “-” button for 2 seconds. |
| Play/ Pause | Press the MFB button once. |
| Answer/ End A Call | Press the MFB button once. |
| Reject A Call | Keep pressing the MFB button for seconds. |
| Activate Siri | Press the MFB button twice. |
| Clear The Pairing List | Press and hold the “+” button and “-” button |
simultaneously for 5 seconds in the pairing mode to clear the pairing list. Then the headphone will automatically enter pairing state.
Voice Prompt
| Power On | Power on |
|---|---|
| Power Off | Power off |
| Pairing | Pairing |
| Successful Pairing | Connected |
| Disconnection | Disconnected |
| Low Power | Battery Low |
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interferencee to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>