beurer HC 35 Compact Hair Dryer Instruction Manual

beurer HC 35 Compact Hair Dryer

IMPORTANT SAFETY NOTES

• The device must only be used for the purpose for which it was designed and in the manner specified in the instructions for use.
• These devices may be used by children over the age of 8 and by people with reduced physical, sensory or mental skills, or a lack of experience or knowledge, provided that they are supervised or have been instructed on how to use the device safely, and have understood the risks involved.
• Children must not play with the device.
• Danger of suffocation! Keep packaging materials away from children.
• Cleaning and user maintenance must not be performed by children unless supervised.
• Do not use this appliance near bathtubs, shower trays or other containers which have water in them.
• Risk of electric shock! Never submerge the device in water or other liquids. If the device falls into water, do not reach into the water! First switch off the fuse at the fuse box and then pull the mains plug out of the socket.
• If using the device in the bathroom, unplug it after use –this is because proximity to water constitutes a danger even when the hair dryer is switched off.
• As an additional safety measure, the installation in the bathroom circuit of a residual current device (FI/RCD) with a rat-ed tripping current not exceeding 30 mA is recommended. Ask your installer for advice.
• This device is not designed for use in commercial areas.
• If the mains connection cable of this device is damaged, it must be replaced by the manufacturer, its customer service department or a similarly qualified person, in order to pre-vent hazards. Do not use the device if it is damaged or not functioning correctly.
• Do not pull, twist or bend the mains cable 11 .
• Do not wrap the mains cable 11 around the hair dryer!
• Risk of fire! Ensure that the air outlet opening 2 and the removable guard are 3 not covered.

SIGNS AND SYMBOLS

The following symbols are used on the device, in these instructions for use, on the packaging and on the type plate for the device:

• This device must not be used near water or in water (e.g. in a wash basin, or in the shower or bath) – risk of electric shock!
• Warning notice indicating a risk of injury or damage to health.
• Dispose of packaging in an environmentally friendly manner
• Read the instructions for use
• This product satisfies the requirements of the applicable European and national directives.
• The device is double-protected and thus corresponds to protection class 2
• The product demonstrably meets the requirements of the Technical Regulations of the EAEU
• Disposal in accordance with the Waste Electrical and Electronic Equipment EC Directive – WEEE
• Manufacturer

DEVICE DESCRIPTION

1. Removable, rotatable professional nozzle
2. Air outlet opening
3. Removable guard
4. ON/OFF button
5. Cold air button (blue)
6. Warm air button (red)
7. LED display
8. Handle
9. Hanging loop
10. Anti-kink protection
11. Mains cable

USAGE

1. Wash hair as usual and then dry with a towel. Hairsprays contain flammable substances, so do not use hairspray while using the hairdryer.

2. Stand on a dry, non-conductive surface and make sure your hands are dry.

3. To switch on the hair dryer, press the ON/OFF button 4 . The hair dryer starts on the medium warm air setting and two red LEDs light up on the LED display

4. Use the warm air button 6 or cold air button 5 to set your preferred level. The illuminated LED display 7 shows the currently set level.
   One red LED = gentle air flow,  warm air
   One blue LED = gentle air flow, cold air
   Two red LEDs = powerful air flow, very warm air
   Two blue LEDs = powerful air flow,cold air
   Three red LEDs= very powerful air flow,hot air
   Three blue LEDs = very powerful air flow,cold air

5. Dry and/or style your hair as you wish.

6. Switch hair dryer off after each use/interruption. To switch off the hair dryer, press the ON/OFF button 4 . The LEDs on the hair dryer go out.

7. Remove the mains plug from the socket.

8. Allow the hair dryer to cool completely on a fireproof surface.

CLEANING AND MAINTENANCE

1. Disconnect the mains plug and leave the device to cool.
2. Remove and clean the guard as shown in figure A. To ensure a long service life, clean the guard at regular intervals.

DISPOSAL

For environmental reasons, do not dispose of the device in the household waste at the end of its useful life. Dispose of the device at a suitable local col- lection or recycling point in your country. Observe the local regulations for ma-terial disposal. Dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment).
If you have any questions, please contact the local authorities responsible for
waste disposal.
You can obtain the location of collection points for old devices from the local or municipal authorities, local waste disposal company or your dealer, for example.

TECHNICAL DATA

• Weight: approx. 560 g
• Protection class: II
• Voltage supply: 2 20-240 V~, 50-60 Hz
• Ambient conditions: only approved for indoor use
• Power consumption: 1600-2000 W
• Permissible temperature range: -10 to +40°C

Subject to technical changes.
The CE mark has been applied in accordance with the following European directives: EMC 2014/30/EU
LVD 2014/35/EU
The Declaration of Conformity for this product can be found at the following address:
https://www.beurer.com/web/we-landingpages/de/cedeclarationofconformity.php
Beurer GmbH • Söflinger Str. 218 • 89077 Ulm (Germany)
www.beurer.com 
www.beurer-healthguide.com
www.beurer-gesundheitsratgeber.com

References

• Beurer Gesundheitsratgeber
• Beurer Health Guide
• MDR & Zertifikate

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>