CHENYU CY-C01 Smart Watch Instructions

: June 5, 2024
: CHENYU

Table of Contents

CY-C01
INSTRUCTIONS
FCC WARNING
Read User Manual Online (PDF format)
Download This Manual (PDF format)

CHENYU CY-C01 Smart Watch

CY-C01

Input voltage/current: DC5V/1.0A
Output power: 5W
Transmission Distances: 4mm
Efficiency: 75%

INSTRUCTIONS

Plug the power adapter into the socket.
USB cable connects to the power adapter.
The watch screen light is a wireless charging indicator light
Put the watch on the launch plate. The watch screen will turn light when it starts to charge. After the watch charged full, it will enter standy mode.

FCC WARNING

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

RF warning for WPT device:
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15cm surrounding the device and 20 cm above the top surface of the device must be respected.