Gateway GATA30812 8 Inch 2GB RAM 32GB 1.6GHz Android Tablet User Guide
- June 5, 2024
- Gateway
Table of Contents
Tablet
Quick Start Guide
Model: GATA30812
Start Here
To Power On
Press and hold the power button to power on. Device will boot up
automatically.
To Power Off
During use, press and hold the power button for about 5 seconds to power off,
a system window will appear.
Select “power off” followed by “ok.” Device will shut down.
Sleep Mode
Tap the Power button to enter/exit sleep mode.
NOTE:
- Please make sure to fully charge your device before powering on.
- For Spanish users, go to “Settings” – “System” – “Language & input”, then go to “Language” to enter “Language preferences”, then click “Add a language”, then choose ‘Espanol”, then choose your regions, then, on “Language preferences” interface, press and move your language to the first place.
Exterior Features
- Front Camera
- Touchscreen
- USB Type-C
- Micro SD Slot
- Earphone port
- Rear Camera
- Volume up
- Volume down
- Power Button
- Reset Button
- Speaker
What’s in the box
- Tablet
- Power Adapter
- Quick Start Guide
- Warranty Book
Caution: The AC adapter included with your device was specifically
designed and approved for your model. Utilization of an after-market adapter
may damage either your device or other devices connected to it. If damage is
determined to have been caused utilization of an unauthorized power supply, it
will not be protected under warranty. For full user manual, please visit
www.gatewayusa.com/support.html
Gateway and the Gateway logo are the registered trademarks of Acer Inc. and
are used under license from Acer America Corporation.
www.gatewayusa.com | Customer Service:
877-777-0649
FCC regulatory conformance:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.
RF Exposure
The SAR limit of USA (FCC) is 1.6 W/Kg averaged over one gram of tissue.
Device has also been tested against this SAR limit. This device was tested for
typical body-worn operations with the back of the device kept 5mm from the
body. To maintain compliance with FCC RF exposure requirements, use
accessories that maintain a 0mm separation distance between the user’s body
and the back of the device. The use of accessories that do not satisfy these
requirements may not comply with FCC RF exposure requirements, and should be
avoided.
The body worn accessories should not contain metallic components in product’s
assembly.