Gateway Plastic Hardware Lighting Co Ltd QSM-2432DV1 22-Key BLE Remote Control Instructions

Gateway Plastic Hardware Lighting Co Ltd QSM-2432DV1 22-Key BLE Remote Control Instructions

22-key BLE remote control specification

: starting up
: shutdown

: Brightness increase or decrease (5 levels), brightness at the lowest or highest will flash two prompts
: Speed increase or decrease (5), brightness at the lowest or highest will flash two prompts

• Red
• Blue
• Yellow
• Orange
• Green
• Warm white
• Cyan
• Purple
• color random keys
• 8 color random flash key
• White light flashes on the bottom
• Random flashes without color
• Synchronous rainbow key
• Gradient key (single press to change color)
• Skip key (single press to change color)
• Automatic mode

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
  Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>