GIKEN Trastem AIO360G High Speed Accurate People Counting Instruction Manual
- June 5, 2024
- GIKEN Trastem
Table of Contents
AIO360G
Installation Manual
Name and Function of Each Part
Sensor with the cover attached
Sensor with the cover removed
Installing the Sensor on the Ceiling
- The direction of the “FORWARD” arrow is captured in the upward direction of the screen.
- Secure the sensor to the ceiling at 4 positions using appropriate screws.
- Connect the LAN cable.
Attaching the Cover
- Check the position of the operation lamp and determine the orientation of the cover.
- Fit the cover into the body.
- Make sure that the two claws on the body are covered.
Network and Count Settings
Connect the sensor to a PC via the LAN and configure the sensor using a
browser (Internet Explorer).
Network settings: IP address, subnet mask, default gateway, etc.
Count settings: Installation height, count area, count direction, etc.
Other settings: Time setting, data transfer setting, etc.
Notes:
- The default IP address is “IP: 192.168.0.249/Subnet Mask: 255.255.255.0”.
- For details of the settings, refer to the relevant instruction manual.
Specifications
Power Supply| Power-over-Ethernet:IEEE802.3af Class 0 or 24 VDC(DC jack),
MAX.10W
---|---
Operating Environment| Indoor use, Temperature 0 to 50°C, Humidity 30 to
85°/o(no condensation)
Sensor Dimensions and Weight| W153.3mm x D138.4mm x H59mm approx.350g
LAN Wiring| CATS or higher, maximum wiring length 100m
LAN Specifications| 10/100Base-T(X), Protocol: TCP/UDP(IPv4), ARP, ICMP, SNTP,
FTP, HTTP
Recorded Data| In and OUT count data is recorded every minute.
Power Interruption Back up for Clock| Approx. 100 hours(Electric double-
layered capacitor)
Accessory| Installation Manual, Safety Manual(this manual)
Giken Trustee Co., Ltd. (Headquarters) 98, Nishi-Dankawara-Cho, Takeda, Fushimi-Ku, Kyoto, 612-8429 Japan Tel: +81-75-641-6000