AcTEC DDAS Dimmer Dali Instruction Manual
- June 5, 2024
- AcTEC
Table of Contents
AcTEC DDAS Dimmer Dali
Product Features
- Dimmable with DALI signal
- 52 mA DALI power embedded for supplying DALI devices
- Built-in on/off and rotary knob dimming control
- Protections: Over-voltage, overload
- Possibility of storing a basic brightness and a fixed power-on brightness
- Stand-by power: <0.5W
- Set single address, group address, scene address or broadcast address via dip switch
**Technical Data
**
Dip Switch Operation
Via dip switch, you can set 64 single addresses(0-63), 16 group
addresses(0-15) and broadcast addresses. Total address value = the sum of the
dip switch value To gel the place value when in “an” position, otherwise will
be 0.
- Short press: ON/OFF
- Turn the knob: Dimming
- ON+double press: Set the start-up brightness.
- OFF+double press: Clear the start-up brightness
- ON+ long-press(l0S+): Set the minimum brightness.
- OFF+ long-press(l0S+}: Clear the minimum brightness
- Auto remembers the last brightness level as start-up brightness, unless you set it.
Installation instruction
Dimensions(mm)
Wiring
- Method 1
- A single DALI group configuration The DALI dimmer can control On/Off and dim for a group of DALI drivers without a DALI controller and DALI PS
- (Set DIP to broadcast) Set Dip switch to broadcast. All devices, max 26, would be controlled as a group.
- A single DALI group configuration The DALI dimmer can control On/Off and dim for a group of DALI drivers without a DALI controller and DALI PS
- Method 2
- A typical DALI configuration The dimmer can be set to Group 1 or 2 through the DIP so as to control G 1 or G2 Set Dip switch to a single address-Only one Device with this address would be controlled.
- Set Dip switch to a group address-AII devices with this group addressed would be controlled. Set Dip switch to the broadcast-AII device. max 26, would be controlled as a group
- A typical DALI configuration The dimmer can be set to Group 1 or 2 through the DIP so as to control G 1 or G2 Set Dip switch to a single address-Only one Device with this address would be controlled.
Remarks: DALI address of each device is assigned by a DALI control system. The address of this DALI dimmer is to be set in relevant to that set by the DALI control system.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>