Shenzhen Soundsoul Information Technology Air3 Pro Wireless Headphones
- June 5, 2024
- Shenzhen Soundsoul Information Technology
Table of Contents
Air3 Pro User Manual
POWERING ON/OFF:
Open the charging case, the earbuds will automatically power on. To power off, place the earbuds into the charging case and close the case.
PAIRING:
Open the charging case, the earbuds will automatically enter the Bluetooth pairing mode. Select ”SOUNDPEATS Air3 Pro” on your device’s Bluetooth list to connect.
CONTROLS:
Under the music mode, tap twice the earbuds can make them pause/play. Under the music mode, press and hold for 1.5 seconds the R earbud can switch to the next track. Tap three times the L earbud can open game mode or exit game mode. Tap three times the R earbud can open Siri or exit Siri. Tap the L earbud can make the volume-, Tap the R earbud can make the volume+. When the call comes in, press and hold for 1.5 seconds the earbuds can reject the call. Or tap twice the earbuds can answer the call and end of the call tap twice again. Press and hold for 1.5 seconds the L earbud can switch to the ANC ON or ANC OFF or Transparency.
RE-PAIRING:
Pairing with another device: Place the earbuds into the charging case and close the case, and then remain the case open, Press and hold the button on the case for 3 seconds until the case Green LED indicator flashes three times to enter pairing mode.
RESET：
Reset if the earbuds cannot properly pair with each other or with other devices. Place the earbuds into the charging case and close the case, and then remain the case open, Press and hold the button on the case for 10 seconds until the case Red LED indicator flashes three times to enter Reset mode. in this way, the earbuds can pair and connect with other devices.
Charging:
If the earbuds is warning of Low voltage, please place the earbuds into the
charging case and close the case, the charging case will automatically charge
for earbuds.
If the charging case is warning of Low voltage, please place the Type-C into
the charging case, the external 5V power supply will automatically charge for
the charging case.
FCC Statement：
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try correct the interference by one or more of the following measures:
- Reorient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into and outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>