2 Replacement Keyless Entry Remote Control Key Fob Clicker Transmitter 3 Button-Complete Features/Instruction Guide

2 Replacement Keyless Entry Remote Control Key Fob Clicker Transmitter 3

Button

Specifications

• DIMENSIONS : 2 x 0.75 x 4 inches
• WEIGHT : 0.32 ounces
• MODEL NUMBER: ‎KPT1306
• BATTERIES: 1 CR2 required
• BRAND: KeylessOption

Introduction

The KeylessOption remote control key is a pair of replacement keyless entry remote for your Ford cars and comes with battery and electronics installed. The replacement key comes with three buttons for remote control. The first is the lock which can be used to lock the car, a beep will be heard when the car is locked. The second is the unlock button which is used to unlock your car. The last is the panic button which is used for non-stop beeping in case of emergencies or accidents. The keys are extremely light weight and are compatible with 2003-2011 Ford E150 E250 E350, 2007-2014 Ford Edge, 2001-2014 Ford Escape, 2002 Ford Escort, 2000-2005 Ford Excursion, 1998-2014 Ford Expedition, 1998-2014 Ford Explorer, 2001-2010 Ford Explorer Sport Trac, 1998-2014 Ford F150 F250 F350 (also Super Duty), 2004-2007 Ford Freestyle, 1998-2011 Ranger, 1998-2003 Ford Windstar, 2006-2008 Lincoln Mark LT, 1998-2003 Lincoln Navigator, 1999-2009 Mazda B2300 B2500 B3000 B4000, 2001-2011 Mazda Tribute, 2005-2011 Mercury Mariner, 2004-2007 Mercury Monterey, and 1998-2010 Mercury Mountaineer.

Programming instructions

STANDARD REMOTE PROGRAMMING (For most models, if this does not work. please try other programming instructions located below)

Please make sure to read through the programming before attempting.

All remotes that are expected to work for the vehicle will need to be with you in the vehicle before attempting to program. Any remotes not present at the time of programming will cease to function until reprogrammed.

1. Enter the vehicle, close, and unlock all doors using the power unlock switch on the driver’s door.
2. Insert the key into the ignition.
3. Within ten (10) seconds, switch the key as far to the ON position as it will go without starting then back to OFF, perform this step eight (8) times ending in the ON position on the eighth (8th) time. Each cycle ON to OFF will count as one if the door locks appear to be cycling after the fourth (4th) ON to OFF cycle, restart the procedure from STEP 1 and only turn the key four (4) times in this STEP, ending in the ON position the fourth (4th) time. At this point the vehicle door locks should automatically lock and unlock, indicating that the programming mode has been activated. If the door locks do not cycle automatically then the programming procedure has failed and you need to restart the procedure from STEP 1.
4. Within seven (7) seconds, using any remote, (we recommend first programming original remotes if you have one) press and release the LOCK button. The vehicle doors will automatically lock and unlock indicating the new remote has been accepted.
5. Repeat STEP 4 for all remaining remotes you wish to program (you can program up to tour (4) remotes total).
6. Once you have programmed all your remotes, exit the programming mode by turning the key off and removing it from the ignition.
7. Test all remotes to ensure they are functioning. If any did not program, restart the programming procedure from STEP 1 and switch the order in which you are programming the remotes.

How to check the compatibility with your Ford Card?

The remote can replace FCC ID CWTWB1U212, CWTWB1U331, GQ43VT11T, and CWTWB1U345. You can check its compatibility with your car by checking the back side of your existing remote.

FREQUENTLY ASKED QUESTIONS

• Does it fit Toyota Prius V?
  No, it doesn’t work with Toyota Prius V.

• Will this work for a 1995 Jeep Cherokee Sport?
  No, it will not work with 1995 Jeep Cherokee Sport.

• Has anyone tried it on a Ford Ranger 2001?
  Yes, it works completely fine with Ford Ranger 2001.

• Would this work for a 1997 Toyota Rav4?
  No, these are for Ford cars only.

• Will this work with 2008 F-450 crew cab?
  The remote can replace FCC ID CWTWB1U212, CWTWB1U331, GQ43VT11T, CWTWB1U345. You can check its compatibility with your car by checking the back side of your existing remote.

• What is the FCC ID number for KPT1306?
  CWTWB1U331 on 315MHz band

• Will this work for a 2007 Ford Focus?
  Yes, this will work with 2007 Ford Focus.

• How do you remove the key fob?
  When you program the new fobs, the previous ones get deleted and only the new ones work.

• Does this work with Toyota Tundra 2002?
  No, it doesn’t work with Toyota Tundra 2002.

• Do you have to have power locks for this to work?
  Yes.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>