EMOS G1120 PIR Motion Sensor Instructions
- June 5, 2024
- EMOS
Table of Contents
EMOS G1120 PIR Motion Sensor
OVERVIEW
Infra-red motion sensors are used for automatic switching of lights in both indoor and outdoor areas. The sensor responds to the heat of persons moving in the detection area. On the intrusion of the detection field, a connected device is automatically switched on for a set period.
Specifications
- Power supply: 220–240 V~, 50–60 Hz
- Maximum load: 1 200 W
- Switching time: min 10 ± 5 s | 7 ± 2 min
- Detection angle: 180 °
- Light sensitivity: <3 LUX ~ 2 000 LUX (adjustable)
- Detection range: max. 12 m (<24 °C)
- Operating temperature: -20 °C to +40 °C
- Relative humidity: <93 %
- Installation height: 1.8–2.5 m
- Detection motion speed: 0.6–1.5 m/s
- Power consumption: 0.45 W (stand by 0.1 W)
- Enclosure: IP44
Note:
Inspect the product before use; if any part is damaged, do not use the
product.Before assembly, make sure the power supply is disconnected. In case
of device failure, do not try to repair or dismantle it. Electromagnetic field
interference, a low-temperature difference between the moving object and its
surroundings, or a glare (e.g. by a strong light source) may result in the
product malfunction.
Sensor function description
The PIR sensor receives infra-red waves emitted by objects in the detection
range. When an object moves in the detection range, the sensor detects the
change and initiates a trigger command “Turn on the light” for the selected
time.
Detection range (sensitivity) – up to 12 m
The “detection range” is an area defined by the detection angle and the
minimum and maximum detected distance from the sensor. The range can be
changed by turning the sensor head.
Setting time (switch-off delay) – TIME 10 s (±5 s) to 7 min (±2 min)
After the last motion is detected, the count-down of the selected time is
started. For the performance test, setting to the minimum value is
recommended.
Twilight setting (light sensitivity) – LUX (3–2 000 lx)
For the performance test, set to the maximum value is recommended. The data
provided is approximate and may vary depending on the location and
installation height. EMOS spol. s r.o. declares that the G1120 is in
compliance with the essential requirements and other relevant provisions of
the Directive. The device can be freely operated in the EU. The Declaration of
Conformity can be found at http://www.emos.eu/download.