EMOS ZC0117 Recessed LED Orientation Luminaire Fitting Instruction Manual
- June 5, 2024
- EMOS
Table of Contents
EMOS ZC0117 Recessed LED Orientation Luminaire Fitting
Recessed LED Orientation Luminaire Fitting
The LED Luminaire fitting is designed to be installed onto a solid base in indoor or outdoor areas. Enclosure: IP65 – for outdoor environments. Check the Luminaire fitting before use and do not use it if you find any of its parts damaged. Before assembly, make sure power supply is disconnected. In case of malfunction, do not try to repair or dismantle the Luminaire fitting. The LEDs are not replaceable. Failure to observe any instructions provided in the manual may result in injury or property damage.
Installation
DIMENSION
| Type | Power source | Power | Luminous flux | Color temperature | Dimensions |
|---|---|---|---|---|---|
| ZC0117 | 220–240 V~, 50/60 Hz | 3 W | 200 lm | 4 000 K | 160 × 70 × 33 mm |
Attach the Luminaire fitting securely to a fixed base in the wall. Connect the power cable for connecting to a 230 V~ power network. The conductor must not be connected to power supply at the time of installation of the Luminaire fitting. Connection of the power cable to the Luminaire fitting may only be done by a professional with relevant qualifications. Proceed in accordance with the enclosed drawing during installation. L = phase conductor (usually black, brown or grey) N = neutral conductor (usually blue)
WARNING
- The Luminaire fitting is only suited for fixed installation.
- The Luminaire fitting may only be connected to an electrical network with installation and protection that is in line with valid regulations and standards.
- Before interfering with the Luminaire fitting or performing maintenance and repair, the Luminaire fitting must be disconnected from the power grid. This must only be done by a knowledgeable person in accordance with valid regulations on qualifications for such activities.
- Immediately take the Luminaire fitting out of operation if any portion of the Luminaire fitting becomes damaged.
- LEDs inside the Luminaire fitting are not replaceable.
- Do not interfere with the internal wiring of the Luminaire fitting.
- Never cover the Luminaire fitting with materials for thermal insulation.
- If the Luminaire fitting housing becomes damaged, do not use the Luminaire fitting and immediately replace the housing with a new one.
DISPOSAL
Do not dispose with domestic waste. Use special collection points for sorted waste. Contact local authorities for in-formation about collection points. If the electronic devices would be disposed on landfill, dangerous substances may reach groundwater and subsequently food chain, where it could affect human health.
References
- Ke stažení - EMOS | Elektro eshop a velkoobchodEMOS | Elektro eshop a velkoobchod
- EMOS | Elektro eshop a velkoobchodEMOS | Elektro eshop a velkoobchod