AUTOSLIDE ATM2 Mode and Sensor User Guide

June 5, 2024
AUTOSLIDE

Mode & Sensor Port Guide

The AutoSlide uses four operating modes. Each mode is designed for a different type of application or method of opening/closing. You can tell which mode the unit is in and change the mode using the mode pad located on the front of the control panel.

Automatic Mode
The default mode for everyday ease and accessibility.

  • Door is unlocked
  • Power-assist enabled
  • Sensors/buttons on Inside and Outside channels enabled
  • Sensors/buttons on Pet and Stacker channels are disabled
Inside Sensor Enabled, opens to full width
Outside Sensor Enabled, opens to full width
Pet Sensor Disabled, functions as safety sensor*
Stacker Sensor Disabled

Hold Open Mode
Keeps the door fully open. Remotes connected to Stacker Sensor can start and stop the door like a garage door.

  • Door is locked when closed (w/ iLock Motor)
  •  Power-assist disabled
  •  Only sensors/buttons programmed to Stacker channel enabled
  •  Sensors/buttons on Inside, Outside, and Pet channels are disabled
Inside Sensor Disabled
Outside Sensor Disabled
Pet Sensor Disabled, functions as a safety sensor
Stacker Sensor Enabled, starts, and stops the door

Secure Mode
Security-centered mode for locking the door.

  • The door is locked (w/ iLock Motor)
  • Power-assist disabled
  • Only sensors/buttons programmed to Inside Sensor channel enabled
  • Sensors/buttons on Outside, Pet, & Stacker channels are disabled
Inside Sensor Enabled, opens to full width
Outside Sensor Disabled
Pet Sensor Disabled, functions as a safety sensor
Stacker Sensor Disabled

Pet Mode
Primary usage mode for humans with pets.

  • Door is locked (w/ iLock Motor)
  • Power-assist enabled
  • Sensors/buttons on Inside, Outside, and Pet channels enabled
  •  Sensors/buttons on the Stacker channel are disabled
Inside Sensor Enabled, opens to full width
Outside Sensor nabled**opens to full width
Pet Sensor Enabled, opens to partial pet width
Stacker Sensor Disabled
  • In any mode but Pet Mode, the Pet Sensor is used for safety sensors: if the door is in the process of closing and Pet The sensor is triggered, the door will automatically reverse back open. Pet Sensor cannot open the door from fully closed when not in Pet Mode.
    ** The Outside Sensor in Pet Mode can be disabled by turning on DIP switch #4 in the unit’s control panel.
    AUTOSLIDE LLC – autoslide.com – 833-337-5433

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals