Electrolux LFT316X Chimney Hood 90 cm User Manual
- June 3, 2024
- Electrolux
Table of Contents
LFT316X Chimney Hood 90 cm
User Manual
LFT316X Chimney Hood 90 cm
WE’RE THINKING OF YOU
Thank you for purchasing an Electrolux appliance. You’ve chosen a product that
brings with it decades of professional experience and innovation. Ingenious
and stylish, it has been designed with you in mind. So whenever you use it,
you can be safe in the knowledge that you’ll get great results every time.
Welcome to Electrolux.
Visit our website to:
Get usage advice, brochures, trouble shooter, and service information:
www.electrolux.com
Register your product for better service:
www.registerelectrolux.com
Buy Accessories, Consumables, and Original spare parts for your appliance:
www.electrolux.com/shop
ENVIRONMENT CONCERNS
Recycle the materials with the symbol. Put the packaging in applicable
containers to recycle it. Help protect the environment and human health and to
recycle waste of electrical and electronic appliances.
CUSTOMER CARE AND SERVICE
Always use original spare parts.
When contacting our Authorised Service Centre, ensure that you have the
following data avai- label: Model, PNC, and Serial Number.
The information can be found on the rating plate.
Warning / Caution-Safety information
General information and tips
Environmental information is Subject to change without notice.
SAFETY WARNING
The minimum distance between the hob surface on which the pans stand and the lower part of the hood must be 65 cm, unless otherwise specifi ed in the installation instructions. If the hob installation instructions specify a greater distance, it must be taken into account. The air collected must not be conveyed into a duct used to blow off smoke from appliances fed with energy other than electricity (central heating systems, thermosiphons, water heaters, etc.). Comply with the offi cial instructions provided by the competent authorities in merit when installing the disposal duct. In addition, exhaust air should not be discharged into a wall cavity, unless the cavity is designed for that purpose. The room must be well aerated in case a hood and some other heat equipment fed with energy other than electricity (gas, oil, coal heaters, etc) operate at the same time. In fact the intake hood, disposing of air, could create a vacuum in the room. The vacuum should not exceed 0,04bar. This prevents the gas exhausted by the heat source from being intaken again. It is therefore advisable to ensure the room contains air taps able to ensure a steady flow of fresh air. Check the data label inside the appliance; if the symbol ( ) is printed, read the following: this appliance has such technical particulars that it belongs to class II insulation, therefore it must not be earthed. Check the data label inside the appliance; if the symbol ( ) is NOT printed, read the following: ATTENTION: This appliance must be earthed. When making the electrical connections, check that the current socket has a ground connection. When making the electrical connections, check that the voltage values correspond to those indicated on the data plate inside the appliance itself. In case your appliance is not fitted with a supply cord and a plug or with other means for disconnection from the supply mains having a contact separation in all poles that provide full disconnection under overvoltage category III conditions, that means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules. If your unit features a power lead and plug, position this so the plug is accessible. Always switch off the electricity supply before carrying out any cleaning or servicing operations on the appliance. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualifi ed persons in order to avoid a hazard.
Warning: Failure to install the screws or fi xing device in accordance
with these instructions may result in electrical hazards.
The appliance must be installed by a qualifi ed person in compliance with the
instructions provided.
Avoid using materials that could cause spurts of flame (flambées) near the
appliance.
Do not flambé under the range hood.
When frying, take particular care to prevent oil and grease from catching fire.
Already-used oil is especially dangerous in this respect. Do not use uncovered
electric grates.
To avoid possible risks of fi re always comply with the indicated instructions
when cleaning grease filters and when removing grease deposits from the
appliance.
This appliance can be used by children aged 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning the
use of the appliance in a safe way by a person responsible for their safety
and understand the hazards involved. children shall not play with the
appliance. Cleaning and user maintenance shall not be made by children without
supervision.
Caution: Accessible parts may become hot when used with cooking
appliances.
This kitchen hood is intended for installation in domestic kitchens above
cooktops, cooking devices, and similar kitchen equipment.
USE
FILTERING OR DUCTING VERSION?
The hood may be in altering or in ducting version. Decide from the outset
which type is to be installed. For better efficiency, we recommend installing
the hood in the ducting
version (if possible).
Ducting version
The hood purifi es the air and evacuates it to the outside through an exhaust
duct.
Filtering version
The hood purifi es the air and recycles the clean air back into the room.
MAINTENANCE
Thorough servicing guarantees correct and long-lasting operation.
Any fat deposits should be removed from the appliance periodically depending
on the amount of use (at least every 2 months). Avoid using abrasive or
corrosive products.
To clean painted appliances on the outside, use a cloth dipped in lukewarm
water and neutral detergent.
To clean steel, copper, or brass appliances on the outside, it is always best
to use specifi c products, following the instructions on the products
themselves.
To clean the inside of the appliance, use a cloth (or brush) dipped in
denatured ethyl alcohol.
Clean grease filiters in relation to use, at least every 2 months to prevent
the risk of fire.
Hand washes or cleans in a dishwasher using a neutral detergent. If washing in
the dishwasher, possible discoloration of the filters does not in any way
compromise their functioning.
The activated charcoal fi lter is not washable and cannot be regenerated, and must be replaced approximately every 4 months of the operation, or more frequently for particularly heavy usage.
CONTROLS
Model LFT316X:
Key A: light switch.
Key B: first speed motor ON/OFF switch.
Key C: second speed switch.
Key D: third speed switch.
Models LFT416X, LFT419X, LFT419W,
LFT419K:
1 : first speed motor.
0 : motor ON/OFF.
2 : second speed switch.
: light OFF
: light ON
LIGHTING
Disconnect the hood from the electricity.
Model LFT316X:
Warning! Prior to touching the light bulbs ensure they are cooled down.
Replace it with lamps of the same type (ø35 E14, 4W).
Models LFT416X, LFT419X, LFT419W, LFT419K:
If the light spot is damaged, it must be replaced only by the manufacturer,
its service agent or similarly qualified persons in order to avoid a hazard.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>