MASTECH MS6818 Advanced Cable Locator User Guide
- June 5, 2024
- MASTECH
Table of Contents
MASTECH MS6818 Advanced Cable Locator
Special attention should be paid when using the test and measurement instrument because the improper usage may cause electric shock and damage the equipment.
- Use proper measurement category (CAT), voltage, and amperage-rated probes, test leads, and adapters for the measurement.
- Do not use or store the device around explosive gas, vapor, or under high temperature and humidity.
- When handling the test probes and crocodile clips, keep your fingers behind the physical guard.
- Examine the measuring test leads (if present) before use. Any element in which the insulation deteriorates (even partially), replace them with proper functional test leads.
- Connect the common test lead before the live test lead and remove the live test lead before the common test lead.
- Before measuring the current, make sure the instrument fuses available and disconnect the power supply to the circuit test
- Remove the batteries if the device is not used for an extended period of time, or if stored in temperatures above45 °C. If the batteries are not removed, battery leakage can damage the device.
Contents
Technical Parameters of Transmitter /
Output Signal| 125kHz
External Voltage| DC12~400V AC12~400V
Fuse| (50~60Hz) ±2.5%
MIN Current| F0.5A 1000V
MAX Current| about 31mA
In Work| about 115mA
In Storage| 0~40°C, with MAX relative humidity of 80%
| 20~60°C, with MAX relative humidity of 80%
Altitude| <2000m
Technical Parameters of Receiver /
Depth of Tracking| The Depth of Tracking Depends on the Material and Specific
Applications
| Material and Specific Applications
Cable| Single pole application: about 0~2m
Locating| Dual pole application: about 0~0.5m
Mode| Single loop line: Up to 2.5m
MIN Current| about 32mA
MAX Current| about 89mA
In Work| 0~40°C, with MAX relative humidity of 80%
In Storage| -20~60°C, with MAX relative humidity of 80%
Altitude| <2000m
