Apple W55 3-in-1 Wireless Charger Instructions
- June 5, 2024
- Apple
Table of Contents
Apple W55 3-in-1 Wireless Charger
Product introduction
This three-in-one wireless charger is exquisite charging support, which can charge three devices wirelessly with one wireless charger.When charging your phone, Watch, AirPods 2,AirPods Pro or other TWS Bluetooth headset cases, you can automatically charge them wirelessly by placing them in the appropriate charging area, which wil make your desktop deaner and your charging more convenient. 1This product is designed to save space and help you integrate your smartphone smart lfe, There is safety protection technobgy in the charging process, charging is safer, 15W high power, charging efficiency greatly increased.
Product appearance
Directions for use
- Please connect the wireless charger to the adapter of 5V/2A-3A,9V/2A-3A, 12V/2A via Type-C fast charging line And power on;
- Put the phone in the charging area to charge it;
- Take out the Apple Watch (the narrowest band is the best) and put it on the watch charger for charging:
- Put the wireless bluetooth headset case on it to charge.
LED state
Support models
For devices with Qi standard wireless charging function. Note: To ensure the safety and efficiency of charging three devices at the same time, it is recommended to use adapters and fast charging lines above 9V/2A. For example,. when the power of mobile phone fast charging reaches 15W, you must use adapters and fast charging lines of 9V/3A or 12V/2A.(If you use an adapter less than 5V/2A the charger may not be able to charge all three devices at the same time)
3 in 1 Wireless charging
Place the device supporting wireless charging in the wireless charging area, and the green indicator will light up to proceed wireless charging. If it cannot be charged normally, please adjust the position of the device until the device shows normal charging or the green light will light up (please refer to the product description icon and place location).When the blue light flashes, the wireless charger detects foreign matter or inputs if the voltage is too high and it is in a protected state, please take care to remove the foreign body or replace the power adapter
Product Parameters
- Name: 3 in 1 Wireless charger
- Input : 5V3A (MAX), 9V-3A(MAX), 12V-2A
- Size: 113 *96 188 mm
- Weight: 320 g
- Transmission distance (mobile phone charging): s5 mm
- Conversion rate (mobile phone charging): 270%
- Output: 15 W/ 10 W/ 7.5 W/5 w
- Watch output: 2.5W TWS
- earphone output: 5W (MAX)
Packing list
- 3 in 1 Wireless charger X1
- Data line X1
- Instruction X1
- Adapter X1
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver IS Connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference recei ved, including interference that may cause undesired operation.
RF Exposure: A distance of 15 cm shall be maintained between the antenna and users, and the transmitter may not be co-located with any other transmitter or antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>