XT60 HGLRC Thor 6 Port Battery Charger Board Lipo Discharger Pro Instruction Manual
- June 5, 2024
- HGLRC
Table of Contents
XT60 HGLRC Thor 6 Port Battery Charger Board Lipo Discharger Pro
Battery Charger Board specifications
- Max Input Current: 40A
- Max Balance Current: 2A
- Cell Count Support: 2-6s
- Battery interface: 6*XT30/XT60
- Size: 10012126mm
- Weight:180.6g
- Charge Connector Protection: Each XT30/XT60 port has its own 15A Automotive fuse
- Battery Balancing Connector Protection: There is an indication of LED shorted in Self-resetting thermal fuses between every balancing pin.
Lipo Discharger specifications
- Input voltage: 2-6s
- The cut-off voltage of discharging of Single-chip: 3.8V
- Battery type: LiPo battery
- Battery interface: XT30/XT60
Lipo Discharger Instructions
-
Working mode the cut-off voltage of Battery discharging: 2S:7.6V; 3S: 11.4V; 4S: 15.2V; 5S: 19V; 63:22.8V
Indicator light: 2S white/3S blue/4S green/5S yellow/6S red -
After the battery is connected, the digital tube displays the battery voltage in real-time, and the white indicator light of the 2S battery flashes
-
Press the key to set the cut-off voltage of discharging (the white indicator flashes for 2S by default when the power is türned on, press once to jump to 3S in turn)
-
When the battery voltage is lower than the cut-off voltage, the digital tube will display for 10 seconds and then turn down, and the corresponding battery the indicator flashes for 10 seconds and then goes out; the discharger will enter a status of low-power sleeping.
-
When the battery voltage drops to the cut-off voltage, the battery indicator light changes from flashing to a constant light after 10 seconds, and the discharger will come in a status of low-power sleeping
Warning:
- When the battery is connected to the changing board, please connect the main output first and then the balance head.At first, the voltage difference should not be too large ( It is recommended that the single section does not exceed 0.1V), otherwise, the fuse may be burned.
- When using the parallel charging board to charge the battery, the battery must have the same number of cells and the same capacity.
- Please make sure the input voltage is within the specified range. The positive and The negative poles are correct. Otherwise, the warranty will be voíded.
- Pay attention to electrostatic protection during transportation and installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>