SILVA 37982 Headlamp User Manual
- June 5, 2024
- SILVA
Table of Contents
37982 Headlamp
User Manual
PRODUCT OVERVIEW
The Exceed 4R packaging contains the following parts:
- Lamp unit
- Headband
- Cable guide (side)
- Rechargeable Li-Ion battery 3.5 Ah
- USB-C charge cable
- Battery holder (2.0 /3.5)
- Quick guide
BEFORE USE
BATTERY CHARGING
The battery needs to be charged before first use.
-
Located on the side of the battery pack is a USB-C connector.
Attach the included USB charge cable to this USB-C connector. -
Connect the USB connection to a wall outlet, computer, or other standard USB connection.
-
On the battery, there are 5 LEDs showing battery status during charging:
• Greenlight (all 5 LEDs) = battery is fully charged
• Red light blinking = battery is charging
The charge time is approximately 4 hours.
Note! When the battery is fully charged the charger automatically
switches to maintenance mode.
Note! Never leave a battery unattended during charging.
Exceed 4R is compatible with all Silva batteries with the same connector as on
Exceed 4R battery. Note that the battery indicator may not be accurate with
other Silva batteries and that the battery won’t fit the battery holder.
ADJUST THE HEADBAND
The headband is ergonomically shaped to give a comfortable fit. Use the 2
buckle adjustments to fit it perfectly to your head. Attach the headlamp to
the head bracket by sliding the headlamp foot into the snap-in socket. To
remove, slide the headlamp up and out of the bracket.
BATTERY CARRYING
The battery pack can be carried in multiple ways; for example on the headband
by using the battery holder, in a pocket, backpack, or on the waist by using
the extension cable and cable guide rear (not included), or mounted on the
bike frame by using the Velcro strap (not included).
The ergonomic battery holder keeps the battery in place and improves comfort
when you carry the battery on your head. You attach the battery holder to the
headband and then easily slide in the battery.
DURING USE
SILVA INTELLIGENT LIGHT AND FLOW LIGHT
Silva Intelligent Light optimizes the light pattern by the unique combination
of a long reach spotlight and a close floodlight. With fewer head movements
and a clear view of near as well as far obstacles, you gain the balance and
confidence it takes to move fast and perform better. Our ingenious Silva Flow
Light takes the optimization even further by
providing seamless tuning of the light pattern for your favorite sport. Simply
tilting the light downwards makes the beams wider to brighten up slower
activities. When tilting the headlamp upwards, the light reaches longer to
provide perfect vision when you move fast.
SWITCH ON YOUR HEADLAMP
A push-button is located on the left side of the headlamp body. This button
controls all light modes.
- To start the headlamp with Flow Light-activated press the push button with a short press.
- To start the headlamp with Flow Light deactivated press and hold the push-button for 1 second
- To cycle between the different modes use short presses.
- To turn the headlamp off press and hold the button for 1 second
DEACTIVATED FLOW LIGHT
Flow Light deactivated means that the Light image will remain unchanged even
if the headlamp is tilted up or down. This might be useful when the lamp is
mounted on a helmet or a bike handlebar.
BOOST MODE
Exceed has a Boost mode that temporarily increases the light output to 2300
lumen in 10 seconds.
To enter Boost mode, do as follows:
- Switch headlamp ON (with Flow light-activated or deactivated)
- Keep the power button pressed until the headlamp turns OFF and keep pressing the button until the headlamp switches back ON.
- The headlamp has now entered Boost mode
- The light will remain in Boost mode for 10 seconds and then return to the light mode from where you entered Boost mode (for example MED)
Note! During the 10 seconds, the headlamp is in Boost mode it is not possible to use the power button.
TEMPERATURE CONTROL:
This headlamp might get hot. The headlamp temperature is depending on light
mode, ambient air temperature, and airflow (speed). Make sure to keep it away
from children. Also, make sure it will not get in contact with sensitive or
flammable material.
NOTE: Always make sure to disconnect the battery when the lamp is not in
use.
Why does the light dim down for no apparent reason?
If the cooling is not sufficient, for instance, if used while standing still,
indoors, or in high temperatures, then the light will automatically be reduced
until an acceptable surface temperature on the lamp body is reached. This
means that the lower the ambient temperature, the stronger the light output.
BATTERY STATUS INDICATION
When the battery is connected and the headlamp is switched on – the current
battery status will automatically be visible for 30 seconds. To check battery
status during use, the headlamp has to be switched OFF and then back ON again.
- 5 green LEDs = Fully charged
- 4 green LEDs = 80% of the battery remains
- 3 green LEDs = 60% of the battery remains
- 2 green LEDs = 40% of the battery remains
- 1 red LED = 20% of the battery remains
To get as much power as possible out of your battery, keep it away from low temperatures during use.
LOW BATTERY WARNING
During the operation of the headlamp, there will be a low battery warning when
10% of the battery energy remains. This is done by flashing both LEDs for 1
second and repeated again after 5 seconds.
RESERVE MODE
During operation, the lamp will go into reserve mode when there is 10% power
left in the battery. All LEDs will flash before the lamp goes into this mode.
Reserve mode can be overridden by pressing the button.
Warning: If you have pressed the button when the headlamp is in reserve
mode no more low battery warnings will appear before the headlamp turns OFF.
AFTER USE
MAINTENANCE
To make sure you get maximum performance from your headlamp, clean it
regularly with a damp cloth. Headband cleaning – rinse in warm water.
TECHNICAL SPECIFICATIONS:
Weight headlamp including headset: | 129 g |
---|---|
Battery weight: | 129 g |
Battery type: | Li-ion 7.4 V, 3.5 Ah |
Light distance Max/Med/Min: | 220 m/120 m/40 m |
Lumen Boost/Max/Med/Min: | 2300/2000/1000/80 |
Burn time 20˚C Max/Med/Min: | 4 h/6 h/20 h |
Burn time -5˚C Max/Med/Min: | 1 h/3 h/20 h |
Reserve mode: | 0.5 h |
Charging time: | 4 h |
Water resistance: | IPX5 |
Operative temperature range: | -20 – +60º |
ABOUT LI-ION BATTERIES
The battery should be stored in a dry environment within the temperature range
of -20°C and +35°C.
If you would like to store your battery for a longer period (more than 30
days) the battery should not be fully charged. This may cause a loss of its
characteristics.
Li-ion batteries have a discharge rate of approx. 20% over a 30-day period.
You can always charge a half-full battery without damaging its
characteristics.
Do not expose the battery to extreme temperatures which may cause fire or
explosion.
Do not disassemble or mistreat the battery; risk of chemical burn.
Keep away from children.
Do not dispose of batteries in a fire. This may cause an explosion.
Do not submerge the batteries in water.
Do not short circuit the contacts.
Replace only with Silva batteries with the same connector as on Exceed 4R
battery.
PROTECTING THE ENVIRONMENT.
Headlamps, batteries, and packaging are recyclable. Please dispose of these
items at designated recycling stations.
WARRANTY
Silva warrants that, for a period of two (2) years*, your Silva product will
be substantially free of defects in materials and workmanship under normal
use. Silva’s liability under this warranty is limited to repairing or
replacing the product. This limited warranty extends only to the original
purchaser.
If the Product proves defective during the warranty period please contact the
original point of purchase. Make sure to have your proof of purchase on hand
when returning the product. Returns cannot be processed without the original
proof of purchase. This warranty does not apply if the product has been
altered, not been installed, operated, repaired, or maintained in accordance
with instructions supplied by Silva, or has been subjected to abnormal
physical or electrical stress, misuse, negligence, or accident. Neither
does the warranty cover normal wear and tear. Silva is not responsible for any
consequences, direct or indirect, or damage resultant from the use of this
product. In no event will Silva’s liability exceed the amount paid by you for
the product. Some jurisdictions do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion may
not apply to you. This warranty is valid and may be processed only in the
country of purchase.
- Batteries: one (1) year
For more information please visit www.silva.se
Visit: www.silva/environment for more information about the Waste Electrical and Electronic Equipment (WEEE) Directive.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>