CREALITY B097T4P4BN CR Touch Auto Bed Leveling Sensor for 3D Printer User Manual

CREALITY B097T4P4BN CR Touch Auto Bed Leveling Sensor for 3D Printer

PACKING LIST

Circuit Principle

Application: Ender-3 Series Ender-5/5S/5Pro | CR-10

Update Firmware

1. Right-dlick the mouse to format SD card. (To make sure the firmware can be flashed successfully, please format the SD card before flashing the firmware)
2. Firmware download (before downloading firmware, please confirm your printer model, motherboard version, and hardware configuration-whether it comes with filament sensor or not). Note: the SD card can only holds one firmware file. File download website: HTTPS: www.creality.com/download
3. Copy the firmware to the SD card. Note: the SD card can only hold one firmware file.
4. Insert SD card.
5. Insert the power cord and press the Switch. Note: Every machine has its own operation interface.
6. Wait for the firmware to complete upgrade (about 10 seconds).

Install CR Touch

1. Insert connectors into 5 Pin Port.
2. Install CR Touch on the rack with 2pcs M3*6 screws.
3. Loosen all fan cover screws, install the CR Touch rack on the corresponding position with 2pcs M3*8 screws.
4. Tie the CR Touch cable together with other printer cables like the above picture shown.

Circuit  Wiing

To connect CR Touch and 32-bit motherboard by 5 pin cable.

Note: Unplug the cable from Z endstop/limit switch.

Steps

1. To get the Z offset Value Operation: Prepare>Auto Home Move Axis Move Z-Please stop to move Z-axis when the distance between the nozzle and the printer bed is about 0.1mm (the height of a sheet of A4 paper). This value shows Z offset value.
2. Input the Z-axis compensation value (Z offset value) Record the Z offset value, then follow below steps and save settings: Prepare Auto home Control Bed Leveling Probe Z offset Input the Z offset value Store Settings
3. Select Bed Leveling, then choose Level Bed. Operation: ControlBed Level ing Level Bed. (Different 3D printers may have different numbers of touching points for automatic leveling. The picture here shows that Ender-3 has 9 points for leveling.)
4. Model Printing After the automatic leveling, user can do a trial print to verify the leveling. Operation: Print from SD CardModel Test (Name and file of the testing model shall be prepared by user.) Example
5. Test passed: leveling is completed and you can print now;
6. Test failed: If model printing fails, please fine-tune Probe Z Offset again and save settings until the printing effect is good.

Note: Every machine has its own operation interface.

Software Settings

1. Open Slicer
2. Settings Printer Manage Printers.
3. Machine Settings.
4. Change “G28” to “G28629”

Appendix 1

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>