MINA KOTA 2207105 Ulterra Trim-Stow Reset Procedures User Manual

MINA KOTA 2207105 Ulterra Trim-Stow Reset Procedures User Manual

In the unlikely event Ulterra will not trim or stow, the following procedure will reset the motor and restore functionality:

1. Press and hold the POWER button located at the mounting base to turn power off (green LED light will turn off).
2. Press the POWER button until the green LED light illuminates.
3. Wait 3 seconds.
4. Press the POWER button 3 times within a 2 second period.
5. Red and green LED lights will flash continuously and the Ulterra will go through the following automated sequence:

• Motor will position itself into the proper orientation
• Motor will automatically trim up to the mounting base and trim down approximately 6 inches.
• The flashing red LED light will turn off, and the flashing green LED light will become solid green.

Ulterra should now be reset and fully functional. If Ulterra does not reset, repeat the procedure. If the second attempt fails, please contact your local authorized service center or call Minn Kota service at 800-227-6433.

NOTE: If the lower unit of the motor is trimmed within 6 inches of the mounting base and the boat hull is obstructing the motor’s turning radius, manually turn the head of the motor so that the lower unit is perpendicular to the motor ramps prior to beginning this procedure.

STOWING FROM THE ULTERRA MOTOR

In the unlikely event your i-Pilot or i-Pilot Link remote becomes non- functioning, you can stow the Ulterra from the base of the motor by completing the following sequence:

1. Ensure that the motor is on.
2. Press and hold the POWER button located at the mounting base for 10 seconds.
3. The red and green LEDs will flash alternately, and motor will begin stow process.

MANUAL STOW PROCEDURE – QUICK REFERENCE GUIDE

In the unlikely event that the motor will not stow from either the remote or foot pedal command, the following alternative stow methods should solve the issue:

1. Trim/Stow Reset Procedure (see reverse side)
2. Stowing from the Motor (see reverse side)
3. If your batteries lose power to the level that the motor will not stow, the motor will most likely stall at a 45 degree angle. If this occurs, reengage power, deploy the motor, trim motor to its highest setting, and turn power off until batteries can be recharged. Once batteries are charged, attempt to stow motor again.

If all three alternative methods have been tried and the motor will still not stow, there is a method to manually stow the motor. However, once the motor has been manually stowed, it will be non-operational until it is manually reset by an Authorized Service Center. If a manual stow must be done, follow the instructions below:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>