REDRAGON M991 Gaming Mouse Instruction Manual

Table of Contents

REDRAGON M991 Gaming Mouse

Thank you for choosing our product. To protect your rights and for better customer service, we ask that you note our warranty rules.

Within guaranty period, repair is guaranteed for failure due to electrical circuit problems. Other damages, such as disassembly, hard impacts, submersion into water, plugging into improper current or voltage, and damage caused by natural disasters such as fire, flood, or earthquake are not included.
Consumable parts (such as foot pad) and spare parts replacement are not included in our warranty.

Windows XP/Vista/Win7 /Win8/Winl O

Left mouse button.
Right mouse button.
Scroll wheel (clicked as middle mouse button).
Side key, defaulted function: Left Forward key on the keyboard.
Side key, defaulted function: Left Backward key on the keyboard.
Fire button.
DPI + button (defaulted to speed up the cursor).
DPI – button (defaulted to slow down the cursor).
Report rate switch button.
User mode toggle key: The mouse switches between the 5 user modes with each click.
Teflon foot pads: Large wear-resistant materials let the mouse move more smoothly.

How to Connect the Mouse with a Computer Wired Connection

Take out the USB to USB C cable in the package and connect the mouse with your computer.
Slide the power switch on the bottom of the mouse to Power On with LED ON or Power On without LED even Power OFF.
The computer will recognize and configure the mouse automatically.
The mouse will be ready for use when the configuration is finished. The LED on left and right size will light on.
The mouse is under recharging whatever the power switch is put to On with or without LED ON. The scroll wheel will light up if the power switch is put to Power ON with LED ON. And it does not light up if the power switch is put to Power On without LED. It may take about four hours for the mouse to be fully recharged.

Take out the USB receiver in the package and plug it into any available USB port on your computer, please note that the USB receiver can be storage on the bottom of mouse.
Slide the power switch on the bottom of the mouse to Power On with LED ON or Power On without LED.
The computer will recognize and configure the keyboard automatically.
The mouse will be ready for use when the configuration is finished. The mouse can work about 9 hours with LED OFF, and about 2 hours with LED ON. The scroll wheel light will flash in Red when battery is low.
Recharge the mouse when the battery is low.

The scroll wheel light will flash in Red when battery is low, you need to recharge the
mouse now.
Take out the USB to USB C cable and connect the mouse and any USB power output port. While the battery is under recharging, the scroll wheel lights up and flash firstly in red (if the battery is very low), then in yellow by 30%-90% charged and finally lights steadily on in Green when the battery is fully recharged.
Charging time is around S hours.
Note: Slide the power switch on the bottom of the mouse to OFF for long term storage.
CAUTION: DO NOT CHARGE THE MOUSE BY WALL PLUG, INPUT VOLTAGE MAX 7V.

User can adjust the following settings through the software after downloading and installing it.

Adjust the DPI of the mouse at the user’s discretion. (range: 100-19000 DPI).
Adjust the polling rate of the mouse at the user’s discretion. (range: 125-250-500- 1000HZ).
Macros: Record up to 59 actions and trigger with one key.
Continuous keystroke function: Set the number of clicks and delay time.
Lighting: Adjust mouse lighting options.
Customize 9 mouse buttons.
Set 5 different user modes and switch between them with the button on the bottom of the mouse.

If the mouse is not responding, please check whether the mouse is turned on or plugged properly in the corresponding computer USB port, or try another USB port.
If the cursor is moving slowly, jumping or intermittent, please try another surface. Surfaces that are dark, dirty, not flat, or bright may affect the performance of the mouse. Use of a mouse pad is recommended.