Futaba SBD-3 Bus Decoder Instruction Manual
- June 5, 2024
- Futaba
Table of Contents
Futaba SBD-3 Bus Decoder
Instruction Manual
ESC connection example
Servo connection example
Channel Setting
If you want to change the output channel from CH3. The equipment by which a channel set is possible.
[Channel change device ]
- CIU-2/3 USB adapter (SBD-Link software for setting)
- T6K, T10J, T12K, T14SG (V4.0-), FX-22 (V4.0-)
- *SBD-Link software can be downloaded from the home page of your region’s Futaba importer.
Refer to each manual for how to change. Follow the same procedure as for changing SBD-1. The SBD-1 has three connectors, each of which sets a CH. For SBD-3, change the CH with the Sx1 setting.
Precautions
WARNING
Failure to follow these safety precautions may result in severe injury to
yourself and others.
- In order to prevent any short circuits, please observe the polarity of all connections.
- Ensure that the unit is connected properly to the receiver.
- If the connector is disconnected during flight, it becomes inoperable.
- Ensure that the unit is mounted in an area that will eliminate exposure to fuel, water and vibration.
- As with any electronic components, prop-er precautions are urged to prolong the life and increase the performance of the unit.
- Allow a slight amount of slack in the unit cables and fasten them at a suitable location to prevent any damage from vibration during flight.
- Used in a set of Futaba S.BUS / S.BUS2 systems.
- To ensure that the SBD-3 is functioning as desired, please test accordingly.
- Do not fly until inspection is complete.
- When using analog servos, make sure the receiver is in normal mode.
- There is the danger of erroneous op-eration or damage on the FASSTest 12ch mode / High-speed mode / S-FHSS.
- Do not supply receiver power from the ESC. When using the receiver power supply type ESC, remove the red (+) cord of the 3ch wiring from the ESC so that the power is not supplied from the ESC
- Use a dedicated battery to power the receiver / servo.
- Do not connect an S.BUS connector of the SBD-3 to other than an S.BUS connection port.
- There is the danger of erroneous op-eration or damage.
- Do not use the SBD-3 with anything other than an R/C model.
- Futaba Corp. will not be responsible for damage caused by combination with other than Futaba Genuine parts.
FUTABA CORPORATION
Hobby Radio Control Business Center Sales & Marketing Department 1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba-ken, 299-4395, Japan TEL: +81-475-32-6051, FAX: +81-475-32-2915
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>