dyson TP09-1PRO Purifier Cool Formaldehyde Air Purifier Instruction Manual

Cool & Heat with Hepa & Plasma
Operating Instruction

Thank you very much for using our products, please kindly read through the manual before usage.

Introduction of Product fittings

1. Output channels
2. Outlet circle
3. Main body| 4. Input channels
5. View screen
---|---

Remote control & Touch screen button comparison

Mode: TP-09PRO
Product size: 265160853(mm)
Voltage: 220V~
Rating frequency: 50Hz
Power rating: 35W (Cool) 1950WHot
Rotation angle: 120°

Air quality monitoring lamp

• Positive and negative oxygen ion mode: the warm wind mode automatically shuts down the positive and negative oxygen ion.

loading and unloading

• Remove: pull out the front hands outwards. Installation: align the filter screen with the groove and press it inside.

Cool Mode

1. Press directly into cool mode
2. Press + or – into ajdust wind power

Hot Mode

1. Press button then press button, hot/cool mode.
2. And press to change back to thenatural wind mode.
3. Warm air mode can be divided into three grades: high, middle, low, 3 grade high, 2 grade middle, 1 grade, and low grade.
4. When the temperature reaches 35 degrees, it will automatically stand by and automatically turn on the warm air mode.

Principle of air outlet

• TP series fans are different from traditional fans, which produce natural air by cutting air, but inhale air through the bottom air inlet, and then generate strong kinetic energy through the high-speed operation of the motor and turbocharging to form a stable and strong high-speed airflow.

Principle of Hot wind

• After choosing the Hot mode, the PTC ceramic heater built in the air duct will begin to heat up. When the air flow passes through the PTC heater, the air flow will
get heating effect, thus releasing pleasant warm air.

Plasma mode

• 1. heating mode automatically turns off plasma.

Clean

• UTurn off the power, unplug the plug, and then wipe it with a clean and wet cloth. Do not use detergent or polishing agent to visually observe whether there is dust at the air outlet/air inlet, and then use a soft brush to remove the dust

Matters needing attention

• This heater is hot when in use and for a short period after use.Do not let bare skin touch hot surfaces. If children are present, consider positioning the heater out of their reach.

Replace Battery

• Tear down the battery hatchcover, take out of used battery, then put the new battery instead of, make battery bin is loaded in the positive & negative direction, and close battery cover.

IMPORTANT SAFETY INSTRUCTIONS
BEFORE USING THIS APPLIANCE READ ALL INSTRUCTIONS AND CAUTIONARY MARKINGS IN THIS MANUAL AND ON THE APPLIANCE.
When using an electrical appliance, basic precautions should always be followed includjng the following:

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY:

1. This heater is hot when in use and for a short period after use. To avoid burns, do not let bare skin touch hot surfaces. When moving the heater hold it by the base, not the air loop amplifier.
2. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains ,at least 0.9m (3 feet) from the front of the heater and keep them away from the sides and rear when the heater is plugged in
3. Extreme caution is necessary when any heater is used by or near children or infirm persons and whenever the heater is left operating and unattended.
4. Do not allow to be used as a toy. Close attention is necessary when used by or near young children, Children should be supervised to ensure that they do not play with the heater or remote control.
5. This heater and remote control are not intended for use by young children or infirm persons with reduced physical, sensory or reasoning capabilities, or lack of experience and knowledge, unless they hove been given supervision or instruction by a responsible person concerning use of the heater to ensure that they can use it safely.
6. The base must be fitted securely before operating. Do not dismantle or use without the base fitted.
7. Suitable for dry locations ONLY. Do not use outdoors or on wet surfaces. Do not use in bathrooms, laundry areas and similar indoor locations. Never locate the heater where it may fall into a bath or other water container. Do not use or store where it may get wet or inthe immediate surroundings of a bath, a shower, or a swimming pool.
8. A heater has hot parts inside. Do not use it in areas where petrol, paint, or flammable liquids are used or stared or where their vapours are present. Do not use in conjunction with or directly next to an air freshener or similar products.
9. Do not locate directly below a mains electricity supply socket.
10. Always plug directly into a wall socket. Never use with an extension cable as overloading may result in the cable overheating and catching fire.
11. Do not handle any part of the plug or heater with wet hands.
12. Do not unplug by pulling on the cable. To unplug, grasp the plug, not the cable.
13. Do not stretch the cable or place the cable under strain. Do not run the cable under carpeting. Do not cover the cable with throw rugs, runners, or similar coverings. Do not route the cable under furniture or appliances. To avoid o tripping hazard arrange the cable away from traffic areas so that it will not be tripped over.
14. Do not use with a damaged cable or plug. If the supply cable is damaged it must be replaced by this company or its service agent or similarly qualified persons in order to avoid a hazard.
15. To disconnect the heater, turn the controls off, then remove the plug from the socket. Always unplug the heater when not in use.
16. Do not use if the heater malfunctions or has been dropped or damaged in any manner. Contact the this company Helpline or return to an authorised service facility for examination and/or repair.
17. To prevent a possible fire, do not use with any opening or exhaust blocked, and keep free of dust, lint, hair, and anything that may reduce airflow. Do not put any object into the inlet grill or the exhaust opening as this may cause an electric shock or fire, or damage the heater.
18. Do not use on soft surfaces, such as a bed, where openings may become blocked.
19. Use only as described in this Dyson Operating Manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
20. In order to avoid overheating and fire hazard, do not cover the heater.
21. Choking hazard: the remote control unit contains a small battery. Keep the remote control away from children and do not swallow the battery. If the battery is swallowed seek medical advice at once
22. The heater should be positioned so the airflow is directed away from any walls or room corners.

IMPORTANT SAFETY FEATURES

For your safety this heater is fitted with automatic cut-out switches that operate if the heater tips over or overheats. If the switches operate, unplug the heater and allow it to cool. Before restarting the heater check and clear any blockages and ensure the heater is on a solid level surface

READ AND SAVE THESE INSTRUCTIONS

THIS APPLIANCE IS INTENDED FOR HOUSEHOLD USE ONLY

Liang Shifu’s Cool and Warm Fan is exempt from insurance for two years Terms and Conditions of One Year Warranty for Your Cooler’s Cooling and Heating Fans

• The warranty clause shall come into force as of the date of purchase.
• All warranty work will be performed by Liang Shifu or his authorized agent.
• Any replacement parts will be owned by Liang Shifu.
• Under the warranty terms, repair and replacement services cannot extend the warranty period.
• Please keep your purchase notes.
• Before repairing your fans, you must provide purchase notes. Without this bill, any work we do will be charged.

Scope covered

• Within one year of purchase, defects due to poor materials, processes or functions will result in the repair and maintenance required (if there is no one component, or production has stopped, Liangshi will replace it with a practical component).

Warranty card

Customer| Full name:| | Warranty Period
Two Years
---|---|---|---
Address:|
Telephone:|
Purchase Date:|
1, The product will be free of charge within two years from the date of purchase.
2, If it is necessary to replace spare parts beyond the time limit specified in the preceding paragraph, the maintenance fee shall be charged as appropriate.
3, During the warranty period, free repairs are not allowed in the following circumstances
a, Failure to query purchase records or provide purchase information
b, Maintenance beyond warranty period.
c, Damage caused by disassembly or renovation.
d, Damage caused by misuse/negligence or improper use.
e, Faults or damages caused by non-ordinary household use (e.g. long-term use in places with poor environment).
f, Those whose appearance is naturally stained by use.| Examination
clerk|
Problem
Description|

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>