WIRELESS PACIFIC X100R Talk Back Microphone User Guide
- June 5, 2024
- WIRELESS PACIFIC
Table of Contents
Talk Back Microphone User Guide
X100R
Parts and functions
Description
Power Off/On: Hold for about 2 seconds to turn on or off. The Power The
mic will sound escalating or de-escalating tones to advise status. The device
does a self-check and the status light then glows. (see Control)
Emergency: Pressing the Orange emergency button triggers the host radio’s
emergency input and causes the status light to glow Red. Additionally, it will
glow Red while any of the connected X10DR Handset users presses their
Emergency button.
Status light: Glows Green when set to transmit to X10DR handsets or Blue
when transmitting over the host mobile radio (see Control). Changes to Red
when Emergency is being activated.
Microphone: Talk in a normal strength voice about 1 to 3cm (~1”) from the
microphone port.
PTT: Press to talk, release to listen. The default assignment is to talk
over the gateway to wireless X10DR handsets. (see Control)
Control: The Control button can be configured so:
A/ It allows the user to toggle the function of the side PTT button between
Radio PTT and Talk around. LED glows Blue when assigned to Radio, and Green
when Talk around.(default) B/ It is the Talk around the button and the side
PTT button is Radio. C/ It is the Radio PTT button and the side PTT button is
Talk around. (See over for re-configuration)
Volume Up/Down : Adjusts the speaker audio to louder/softer and sounds a
beep when pressed.
Initial set-up
When first installing a Talkback Mic to your X10DR gateway system set the
microphone output level to match the host mobile radio’s first Mic and if
desired, set receive input level if you want the host mobile radio’s receive
audio to also be heard through the XTBM speaker.
Microphone transmit level adjustment: (Using a portable radio to monitor
transmit audio)
To match the XTBM’s transmit audio level to the host radio’s first microphone
requires the following: Hold the Volume Up button while turning on XTBM. After
activation of tone sounds, release buttons. Listening to the portable,
transmit on the radio’s fist microphone and then transmit on the Talkback Mic.
Use the Volume Up/Down buttons to adjust XTBM transmit audio level so the XTBM
matches the radio’s wired fist microphone. To lock the audio level, press the
top grey button.
Radio Receive input level adjustment: (Default level is off)
To match the wireless X10DR’s audio and the host radio’s received audio level
requires the following: Hold the Volume Down button while turning on XTBM.
When the activation tone sounds, release the buttons. Speak into a portable
radio so that you can monitor the host mobile’s receive audio output. Next,
transmit on the wireless X10DR handset and compare levels. Use the Volume
Up/Down buttons to adjust the XTBM’s volume so the portable radio’s audio is
the same level as when you talk on the wireless X10DR handset. To lock the
audio level, press the top grey button.
Control Button PTT Re-assignment Options:
A/ Control button toggles PTT between Talk around and Radio PTT.
– Power up with the orange button pressed. (Default)
B/ Side PTT button to be Radio PTT and top Control is Talk around PTT.
– Power up holding the Control GREY button.
C/ Side PTT button to be Talk around PTT and top Control is Radio PTT.
– Power up with side PTT pressed.
XCA adaptor
Radio specific – specify type when purchasing. Connects to the rear interface
connector on your mobile
radio. Connect the RED wire to the vehicle’s permanent battery supply.
WHITE wire, if supplied, is for Remote PTT use – do not connect unless
required.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>