KLARK TEKNIK PRO DI DI 10P Passive DI Box with Stereo Input-Summed Mono Output User Guide
- June 5, 2024
- Klark Teknik
Table of Contents
KLARK TEKNIK PRO DI DI 10P Passive DI Box with Stereo Input-Summed Mono
Output User Guide
Product overview
Controls
Step 1: Controls
INPUTS – Connect your source audio via stereo RCA jacks or a single 1/8″ TRS jack. The unused input jack can act as a loop-through output. A mono source can also be connected to one of the RCA jacks, or to the 1/8″ input.
LEVEL L/R – The level of the left and right channels can be adjusted before being sent to the output jack. Normally these knobs should be set fully clockwise, but may be used to attenuate very hot signals, or to correct the balance between the channels.
OUTPUT – Send the summed inputs to a mixing console via balanced XLR
cable.
The output level is approximately 20 dB lower than the input signal.
EARTH LIFT – This switch may help reduce unwanted hum by removing the ground connection.
Specifications
Inputs
Connectors|
Impedance 7 kΩ|
Outputs
Connector|
Impedance|
System
Frequency response|
THD + N (distortion)|
Signal-to-noise ratio|
Power requirement|
Physical
Dimensions (W x D x H)|
Weight|
LEGAL DISCLAIMER
Music Tribe accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein. Technical specifications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. Midas, Klark Teknik, Lab Gruppen, Lake, Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera, Oberheim, Auratone, Aston Microphonesand Coolaudioare trademarks or registered trademarks of Music Tribe Global Brands Ltd. © Music Tribe Global Brands Ltd. 2021 All rights reserved.
LIMITED WARRANTY
For the applicable warranty terms and conditions and additional information regarding Music Tribe’s Limited Warranty, please see complete details online at musictribe.com/warranty.
FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION
Klark Teknik
PRO DI DI 10P
Responsible Party Name: Music Tribe Commercial NV Inc.
Address: 5270 Procyon Street, Las Vegas NV 89118, United States
PhoneNumber: +1 702 800 8290
PRO DI DI 10P
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Important information:
Changes or modifications to the equipment not expressly approved by Music Tribe can void the user’s authority to use the equipment.
Hereby, Music Tribe declares that this product is in compliance with Directive
2014/30/EU, Directive 2011/65/EU and Amendment 2015/863/EU, Directive 2012/19/
EU, Regulation 519/2012 REACH SVHC and Directive 1907/2006/EC.
Full text of EU DoC is available at https://community.musictribe.com/
EU Representative: Music Tribe Brands DK A/S
Address: Ib Spang Olsens Gade 17, DK – 8200 Aarhus N, Denmark
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>