KLARK TEKNIK PRO DI 2 DI 20P Passive Stereo DI Box with Midas Transformer and Extended Dynamic Range User Guide

June 5, 2024
Klark Teknik

KLARK TEKNIK PRO DI 2 DI 20P Passive Stereo DI Box with Midas Transformer and Extended Dynamic Range User Guide
KLARK TEKNIK PRO DI 2 DI 20P Passive Stereo DI Box with Midas Transformer
and Extended Dynamic Range

Product Overview

Product Overview

Product Overview

Controls

Step 1: Controls
IN/THRU – Connect your high-impedance source audio to the left and right ¼” TS jacks. Instrument-level, line-level and even speaker-level sources are accepted. Each input jack has its own loop-through output. A common scenario allows an instrument to be connected to the input(s), and the Thru jack passes the signal to an amplifier while the XLR output is sent to a mixing console.
A mono in / dual mono out can also be achieved by connecting a single ¼” cable to the left input, then using a short patch cable to connect the left thru jack to the right input. This will send the single input source to both XLR outputs.
PAD – A -15 dB pad can be applied to each channel for very hot signals. This does not affect the level of the thru jacks.
OUTPUTS – Send the inputs to a mixing console via balanced XLR cables.
EARTH LIFT – This switch may help reduce unwanted hum by removing theground connection.

Specifications

Inputs

Connectors| 2 x ¼” TS unbalanced
Impedance| 10 kΩ/PAD , 500 kΩ/off
Max. input level| 30 dBu @ 1 kHz
Outputs
Connector| 2 x XLR, balanced
Impedance| 150 Ω, 1 kHz
Max. output level| 8.5 dBu @ 1 kHz
System
Frequency response| 20 Hz to 30 kHz (± 1 dB)
THD + N (distortion)| 0.01% @ 1 kHz, 0 dBu
Signal-to-noise ratio| 108 dBu
Input pad| -15 dB
Power requirement| Passive
Physical

Dimensions (WxDxH)

|

118 x 112 x 64 mm
(4.6 x 4.4 x 2.5″)

Weight| 0.54 kg (1.2 lbs)

LEGAL DISCLAIMER

Music Tribe accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein. Technical specifications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. Midas, Klark Teknik, Lab Gruppen, Lake, Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera, Oberheim, Auratone, Aston Microphonesand Coolaudioare trademarks or registered trademarks of Music Tribe Global Brands Ltd. © Music Tribe Global Brands Ltd. 2021 All rights reserved.

LIMITED WARRANTY

For the applicable warranty terms and conditions and additional information regarding Music Tribe’s Limited Warranty, please see complete details online at musictribe.com/warranty.

FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION

Klark Teknik
PRO DI 2 DI 20P

Responsible Party Name: Music Tribe Commercial NV Inc.
Address : 5270 Procyon Street, Las Vegas NV 89118, United States
Phone Number: +1 702 800 8290

PRO DI 2 DI 20P
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

  1. this device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

Important information:
Changes or modifications to the equipment not expressly approved by Music Tribe can void the user’s authority to use the equipment

Hereby, Music Tribe declares that this product is in compliance with Directive 2014/30/EU, Directive 2011/65/EU and Amendment 2015/863/EU, Directive 2012/19/ EU, Regulation 519/2012 REACH SVHC and Directive 1907/2006/EC.

Full text of EU DoC is available at https://community.musictribe.com/

EU Representative: Music Tribe Brands DK A/S
Address: Ib Spang Olsens Gade 17, DK – 8200 Aarhus N, Denmark

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Klark Teknik User Manuals

Related Manuals