KLARK TEKNIK PRO SPLITTER 5 DS 50 Passive 1-In – 5-Out Signal Splitter User Guide

June 5, 2024
Klark Teknik

KLARK TEKNIK PRO SPLITTER 5 DS 50 Passive 1-In – 5-Out Signal Splitter

KLARK TEKNIK PRO SPLITTER 5 DS 50 Passive 1-In - 5-Out Signal
Splitter

INPUT

Connect the source audio to the DS 50 via XLR cable. The connector will accept line-level or microphone signals. To disconnect the XLR cable, press the tab while pulling the connector out.

Specifications

  • input Connector: XLR, balanced
  • output Connectors: 5 x XLR, balanced
  • Frequency response: 20 Hz to 22 kHz (± 0.05 dB)
  • THD + N (distortion): < 0.01% @ 1 kHz,+4 dBu
  • Signal-to-noise ratio: 121 dB
  • CMRR: 98 dB typical
  • Insertion loss: 0.05 dB @ 100 kΩ, 0.7 dB @ 600 Ω
  • Power requirement: Passive
  • Dimensions (W x D x H): 118 x 112 x 64 mm (4.6 x 4.4 x 2.5″)
  • Weight: 0.43 kg (0.9 lbs)

LEGAL DISCLAIMER

Music Tribe accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein. Technical specifications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. Midas, Klark Teknik, Lab Gruppen, Lake, Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera, Oberheim, Auratone, Aston Microphones and Coolaudio are trademarks or registered trademarks of Music Tribe Global Brands Ltd. © Music Tribe Global Brands Ltd. 2021 All rights reserved.

LIMITED WARRANTY

For the applicable warranty terms and conditions and additional information regarding Music Tribe’s Limited Warranty, please see complete details online at musictribe.com/warranty.

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation.

Important information:
Changes or modifications to the equipment not expressly approved by Music Tribe can void the user’s authority to use the equipment.
Hereby, Music Tribe declares that this product is in compliance with Directive 2014/30/EU, Directive 2011/65/EU and Amendment 2015/863/EU, Directive 2012/19/EU, Regulation 519/2012 REACH SVHC and Directive 1907/2006/EC.
Full text of EU DoC is available at https://community.musictribe.com/
EU Representative: Music Tribe Brands DK A/S
Address: Ib Spang Olsens Gade 17, DK – 8200 Aarhus N, Denmark

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Klark Teknik User Manuals

Related Manuals