DELUX SK800GL 2.4G Wireless Silent Keyboard User Manual
- June 5, 2024
- DELUX
Table of Contents
DELUX SK800GL 2.4G Wireless Silent Keyboard
Package content
- KeyboardX1
- Manual X1
- Type-C Cable X1
- ReceiverX1
Compatibility
Compatible with Windows 7/8/10/Mac OS (No software)
User instruction
-
Connecting way
Bottom switch on.plug the receiver,use it after the device finished matching. -
Light-changing mode
Click* light key to change lighting mode, light is set by default, it also has breath mode and close mode.
Key function
FN combination key
- FN+F1= open the media
- FN+F2= volume down
- FN+F3= volume up
- FN+F4= turn off volume
- FN+F5″‘ last play
- FN+F6= next play
- FN+F7″‘ start/stop
- FN+FB= turn off
- FN+F9= open the internet
- FN+F1 0= open the mail
- FN+F11 = open my computer
- FN+F12= open the favorite
- FN+PageUp”‘ add the brightness of light
- Fn+Page□own”‘ reduce the brightness of light
- Fn+Win”‘ lock. the function of Win
indicator light icon
- Numeric key indicator light
- Shift indicator light
- charging/low battery indicator light
Low voltage indicator: when the voltage is lower than 3.2V, the low voltage indicator will flash to remind the user to charge.
The Code way
It has been set by the factory in default. You can force to set it by pressing
“ESC+K” for 3 seconds if needed. When all the indicators flash, insert the
receiver and then complete the matching.
Charging method
(with a 1100mA lithium battery) Insert the USB charging cable. The charging
indicator (white light ) is always on and it goes off when the charging is
completed. The charging current is set to 500-S00mA and the estimated time to
complete the charging is about 2 hours. The fully charged keyboard can be used
for around 10 hours in fully backlight. The keyboard can be used normally
during the charging.
Caution
Risk of explosion if the battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions.
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.