Omni G3-EB-OM-NA-P IoT Controller Device User Manual
- June 5, 2024
- Omni
Table of Contents
IoT Controller using manual
Product Name: IOT device
Product Model: G3-EB-OM-NA-P
Product introduction
This is a sharing scooter iot controller, through 4G GPS, BLE5.2 Bluetooth, and a smartphone APP for data communication to control the startup/shutdown of the scooter, the cloud server automatically counts the time and deducts the fee.
Product working for frequency band
APP installation and registration:
- For APP download, please go to the official website corresponding to the mobile phone operating system to download and install it.
- User account registration and login. This step requires the mobile phone to be connected to the Internet, and the user account is a normal mobile phone number.
- Deposit recharge, car fare recharge.
On/off operation instructions:
- Turn on Bluetooth in the mobile phone system.
- Open the APP, click the QR code button in the middle below the APP, enter the scan QR code page, and scan the QR code with the iot controller. When the mobile phone scans and reads the QR code information, the lock will automatically open and enter the state of using the car.
- When the car is used up, click close the lock, and the cloud service will automatically stop the time counting and deduct the charge after receiving the lock.
The IOT controller needs to be used with a smartphone, and the mobile phone hardware environment requires：
Android 4.3 or above, hardware support Bluetooth 4.0BLE, the best screen resolution is 1280×720; IOS 7.1 or above, iPhone 4s or above.
APP page introduction
home page
Scan the QR code page
Unlock and use the car page
Successful deduction page
CAUTION
Risk of explosion if the battery is replaced by an incorrect type;
disposal of a battery into fire or a hot oven, or mechanically crushing or
cutting of a battery, that can result in an explosion;
leaving a battery in an extremely high temperature surrounding environment
that can result in an explosion or the leakage of flammable liquid or gas;
a battery subjected to the extremely low air pressure that may result in an
explosion or the leakage of flammable liquid or gas
Statement:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Statement:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between your body.
Innovation, Science, and Economic Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>