INDESIT IWDE12 Washer Dryer Instruction Manual
- June 5, 2024
- INDESIT
Table of Contents
**INDESIT IWDE12 Washer Dryer Instruction Manual
**
Operating Instructions
Control Panel
Starting a wash cycle
- Switch the washer-dryer on by pressing . All the LEDs will light up for a few seconds and the On-Off/Door Lock Led will begin to flash.
- Load your laundry into the washer-dryer and shut the appliance door.
- Set the Programme knob to the programme required.
- Set the wash temperature
- Set the drying cycle if necessary
- Add the detergent and any fabric softener
- Start the programme by pressing the Start/Reset button. To cancel it, keep the Start/Reset button pressed for at least 2 seconds.
- When the programme is finished, the On-Off/Door Lock LED will flash to indicate that the appliance door can be opened. Take out your laundry and leave the appliance door ajar to allow the drum to dry thoroughly. Turn the washer-dryer off by pressing button .
Programme table
Setting the temperature
Set the drying cycle
Turn the drying knob to select the desired drying option.
There are two options:
A- Based on time: From 40 minutes to 150.
B- Based on the damp level of the dry clothes:
Iron: Slightly damp clothes, easy to iron.
Hanger: Dry clothes to put away
Cupboard: Very dry clothes, recommended for toweling and bathrobes.
A cooling stage is foreseen at the end of the drying cycle.
If your laundry load to wash and dry is in excess of the maximum load (see table below), perform the wash cycle and when the programmed is complete, divide up the garments and put part of them back in the drum. Now follow the instructions provided for a dry only cycle. Repeat this procedure for the remainder of the load.
Table of drying times
Drying only
Turn the programme knob to one of the drying settings depending on the type of fabric, then select the desired drying type using the drying knob. A spin cycle is carried out during the drying, if you have set a cotton programme and a level of dryness (cupboard/hanger/iron).
Functions
To enable a function:
- Press the button corresponding to the desired function, according to the table below.
- The function is enabled when the corresponding indicator light is illuminated.
Note: The rapid flashing of the button indicates that the corresponding
function cannot be selected for the programme set.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>