Shark NV341 Series Rotator Slim-Light Lift-Away FAQs
- June 9, 2024
- Shark
Table of Contents
Shark NV341 Series Rotator Slim-Light Lift-Away FAQs
This article contains the FAQs for the NV341 Series Shark® Rotator® Slim-Light Lift-Away®. This supports the following product SKUs NV341, NV341Q, NV342Q and NV345C.
FAQs
General questions about using the vacuum:
How do I assemble my vacuum?
Place the vacuum body onto floor nozzle.
Insert the wand into top of the vacuum.
Insert the handle into the top of the wand.
Insert the hose into the hose connector.
Insert the crevice tool and dusting brush into the accessory holder as shown.
How do I remove the handle to clean above floors?
To clean with the hose, press the handle release button then lift the handle up.
How do I remove the handle with extension wand to clean above floors?
To clean with the hose, press the wand release button then lift the handle up.
How do I detach the pod for portable cleaning?
Press LIFT-AWAY to lift the pod off the floor nozzle.
General questions about maintenance:
How do I clean the filters and how often?
Pre-Motor Filters:
Remove the dust cup, pull the two filters out from the top of the motor housing, rinse the filters thoroughly in lukewarm water until the water runs clear, squeeze out excess water and let air-dry for at least 24 hours before replacing. To replace, put the felt filter in first, then add the foam filter.
Hepa Filter:
Remove the filter cover from the front of the vacuum by pulling up on the tab and pulling the cover away from the vacuum. Take out the HEPA filter by pulling it straight out, turn the filter over so that the dirty side is on the bottom and vigorously tap it clean against a trash can to remove any dust. Wash the filter under the tap using lukewarm water with the dirty side face down until the water runs clear. Allow the filter to air dry for 24 hours. Once the HEPA filter is dry, replace it back into the vacuum, and then replace the cover by inserting the two tabs into the holes at the top and then swinging the cover down until it clicks into place.
How do I empty the dust cup and how often?
Pull up on the dust cup release latch and lift the dust cup off the pod.
Holding the dust cup over a garbage bag or can, press the bottom empty release latch.
Press the top dust cup release latch to access the dust screen and remove built-up debris as required. Turn the dust cup over and empty the upper chamber by holding it by the recessed handle underneath the dust cup.
How do I maintain the brushroll?
Remove floor nozzle from the pod.
Using a coin, turn the locking screws to the unlock position and pull up to expose the airway. Remove any obstructions, close and relock.
Remove any string, carpet fibers or hair that may be wrapped around the brushroll.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>