DISCOUNT CAR STEREO A2D-HON Audio Streaming Adapter Installation Guide

DISCOUNT CAR STEREO A2D-HON Audio Streaming Adapter

Introduction

They are literally thousands of older Hondas and Acura’s on the road that still has the original radio in place that unfortunately lack support for Bluetooth, but thanks to A2D-HON these radios can be upgraded to support Bluetooth music streaming. Installation could not be simpler and only requires connecting Bluetooth module to the 8-pin CD changer socket, pairing Bluetooth device and be their way to enjoying music, navigation, audio books and other important applications on the car system! Because this module uses the “CD” port, factory single CD or CD changer (if present) must be disconnected. Warning!! All compatible radios must have a “CD” button on face and 8-pin socket at the rear. Radios with 8-pin socket at the rear but missing “CD” button on faceplate (e.g., models: 1100, 1901, 2100, 2300 etc.) are NOT compatible.

Installation

1. Remove radio to gain access to the connector vehicle specific radio removal instructions are not included but available upon request
2. Disconnect any accessory connected to 8-pin connector
3. Connect module 90-degree 8-pin plug to radio or slave cassette player 8-pin port.

Pairing

Pairing process varies between devices but basic steps are the same. Pairing is done upon initial install and will not have to be repeated.

1. Turn ignition and radio “ON”
2. On Bluetooth device: Go to Settings/Wireless & Networks/ Bluetooth Settings.
3. Select Bluetooth and turn on.
4. Go to Bluetooth settings.
5. Tap “Scan” for devices.
6. Wait for Bluetooth device name to appear and select it.
7. Confirmation heard on car speakers.

Optional Remote Control

Wireless remote is not required for module to work as described, however instead of fumbling audio device, you simply press the familiar remote-control buttons while also keeping your eyes on the road.
Optional remote control allows users to:

1. Control music wirelessly
2. Activate VR commands (Google only)
3. Track up/down
4. Volume up/down

Pairing Remote Control

Operation

Use wireless remote to perform the following functions on any iOS7.0 and higher or Android 4.4 and higher.

Contents

Operation

1. Turn ignition and radio “ON”

2. Press “CD” or “CD/TAPE” button on radio until display changes to CD mode. CD display mode
   If radio does not switch to CD, cycle ignition OFF/ON and try again.

3. Launch streaming application on smart device.

4. Use radio volume button to set playback level and ensure smart device volume is raised to 85% or higher. If playback is distorted, lower volume smart device or if inaudible, raise volume on both smart device and/or radio.
   Warning Playlist and track selection NOT possible from radio buttons. Use smartphone built-in controls and display to access and control audio files and applications.

5. If correct operation is confirmed go ahead and reinstall radio.

FAQs & Troubleshooting

1. Does the A2D-HON work on all Honda radios? NO The A2D-HON works on select 1992-01 Honda CD changer controlling radios. CD changer controlling radio will have a CD or CD/TAPE button on face AND 8-pin socket at the rear. Honda radios missing the CD or CD/TAPE button are not compatible even with 8-pin socket at the rear. Must have both
2. My radio has a built-in 6 CD changer, will the A2D-HON work? Most (if not all) Honda 6-CD changer radios (changer built-into radio) do NOT support an external device lacks 8-pin CD and therefore not compatible. Many Acura 6-CD changer radios DO support external devices. Please check for 8-pin DIN socket prior to purchase.
3. Can I use the Honda radio buttons to control streaming device? NO Use device built-in controls to browse music library.
4. Will I be able to make phone calls using this module? NO the A2D-HON supports music streaming not hands-free calls.
5. What happens if a call comes in while streaming? Streaming will mute during call and resume upon ending call. Call taken on handset as customary.
6. Can I connect module to the CD changer plug in trunk/hatch? YES/NO; If vehicle has original CD changer, the module can be connected to CD changer cable terminal however  if vehicle has an aftermarket CD changer e.g. Alpine etc module must be connected to radio.

Disclaimer

• This product has no affiliation with Honda, Acura.
• We’re not liable for misuse of this product.
• We recommend professional installation.

Email: support@discountcarstereo.com
1995-Feb-22 Discount Car Stereo Inc. All rights reserved. Information in this document is subject to change without notice. Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>