RIBITECH PRCEN003 800W Empty Cendre Cenerix Vacuum Cleaner User Manual
- June 5, 2024
- RIBITECH
Table of Contents
RIBITECH PRCEN003 800W Empty Cendre Cenerix Vacuum Cleaner
WARNING:
Carefully read this instruction manual before operating this appliance.
Incorrect operation may cause injury and/or damages.
Please keep this manual for future reference.
USED SYMBOLS AND THEIR EXPLANATION
- Do not dispose of this product with household rubbish. Dispose of this product in the nearest recycle centre.
- Please contact your local authority or local recycle centre for further information for its safe disposal.
- Class II product with double insulation
- Wear eye protection.
- Wear protective gloves
- Keep children away.
The use of this product by children is forbidden.
Keep the product away from children or from their environment.
Never allow children to operate the appliance. Children should be supervised to ensure that they do not play with the product.
Never leave the product unattended.
Unpacking: Remove product from its packaging. Check that product and accessories are not damage.
The use of this product by children is forbidden.
Original Instructions
Congratulations for your excellent choice.
Our ash vacuum cleaner is not only a top quality and highly reliable product,
but it is also easy to use and offers a safe and long-lasting operating life.
It has been designed to vacuum only cold ash. It is not suitable for boilers
or for fuel oil stoves nor can it be used for plaster powder or cement dust.
The equipment is designed for domestic use.
IMPORTANT – Safety warnings – Read carefully before use!
- Do not leave the ash vacuum cleaner plugged in when not in use. Always stop the appliance with the ON/OFF switch before taking the plug out of the socket.
- Do not pull the lead. To unplug, grasp the plug, not the cable. The use of an extension cable is not recommended.
- Do not pull or carry by cable or use cable as a handle.
- Do not use to vacuum water or other liquids.
- Do not use to pick up flammable or combustible liquids, such as petrol, or use in areas where they or their vapors may be present.
- The cover of the motor compartment must only be cleaned with a dry cloth.
- Do not leave the ash vacuum cleaner outdoors, it must always be kept in a dry place and not where it could be affected by bad weather conditions.
- Do not handle any part of the plug or appliance with wet hands.
- Do not disassemble the appliance as incorrect reassembly may result in an electric shock or fire.
- Do not stretch the cable or place the cable under strain. Keep the cable away from heated surfaces. Do not close a door on the cable, or pull the cable around sharp edges or corners. Arrange the cable away from traffic area and where it will not be stepped on or tripped over.
- Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
- Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts, such as the brush bar. Do not point the hose, wand or tools at your eyes or ears or put them in your mouth.
- Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce airflow.
- To avoid a tripping hazard wind the cable when not in use.
- Hold the plug when rewinding onto cable reel. Do not allow the plug to whip when rewinding.
Electric lead: if the electric lead is damaged, it must be replaced by the manufacturer, by the manufacturer’s customer service or by qualified people.
- This device is not intended for use by people (including children) with limited physical, sensorial or mental capacities or by people lacking in experience or knowledge unless they are assisted or shown how to use the appliance by a person responsible for their safety.
HOW TO PREPARE AND USE THE ELECTRIC ASH VACUUM CLEANER
- Position the appliance on a flat surface.
- Make sure the HEPA filter is fitted in its housing (fig. 1)
- Connect the steel pipe to its fitting. (fig. 2)
- Before cleaning the stove make sure that it has cooled down properly. Before vacuuming the ash, check that it is cold and no longer alight.
- Plug the electric lead into a socket, making sure the voltage is suitable for the characteristics of the appliance, check the rating label on the appliance.
- Turn the appliance on using the luminous ON/OFF switch located on the cover of the motor.
- Vacuum the ash directly from the fireplace or from the stove using the steel pipe.
- If the suction power decreases, turn the motor off using the switch and when the motor has stopped completely, lift the lid and remove the filter from its housing turning it slightly. Wash the filter under a gentle jet of running water at room temperature in order not to damage it. Use a soft brush to remove the more stubborn residue.
Do not use hot water otherwise the filter may warp.
- Do not use detergents. Leave the filter to dry naturally before replacing it in its housing. Do not place it close to hot sources of heat. Do not place it in direct sunlight.
- It is advisable, in any case, to clean a max. of 2/3 kg of ash during each cleaning operation. When the stove or fireplace has been cleaned, the appliance and suction filter must then be cleaned as described above. The cleaning operations should be done outdoors.
- Position the steel pipe in fitting (fig.3) by jointing the connection supplied with the machine (fig.4) and turn the appliance on using the switch. Direct the outlet of air towards the filter and, if necessary, shake the filter with the metal nozzle located on the outside of the pipe.
- Once the filter has been cleaned, check whether it is suitable for further use. If it has been damaged or broken, replace it with an original Ribimex HEPA filter.
- To take out the filter, remove it forcefully.
- To insert the new filter, press on it as far as it will go.
PREFILTER FOR HEPA FILTER
The prefilter, applied over the HEPA filters, prevents the ash to get in
contact with the filter lengthening the duration of suction.
To ensure efficient suction, fit onto the HEPA filter (fig. 1) the fabric pre-
filter as shown in fig. 2.
With the prefilter completely applied (Figure 3), use the ash cleaner as
indicated in the user and maintenance manual.
For proper maintenance and suction power, the pre-filter and HEPA filter can
be washed in water and must be dried thoroughly before use.
BLOWING FUNCTION
To use the blowing function, insert the pipe in the air outlet hole as shown in fig. 3 when the equipment is switched off and fit the connector shown in fig. 4 that is supplied with the equipment on the end of the pipe. Turn the ash cleaner on using the switch.
CLEANING AND MAINTENANCE
CAUTION: Before carrying out any cleaning or maintenance operation, the
plug must always be removed from the socket.
The container and the filter should be cleaned quite regularly to ensure the
equipment works properly. If the equipment does not work satisfactorily, it
may be due to the presence of residue or dirt inside the filter or the pipe.
In this case, it is advisable to turn off the equipment, remove the plug from
the socket and then clean the parts.
If these instructions are not followed, the guarantee will automatically
become null and void.
The only filter that can be cleaned – replaced by the user is HEPA filter
group with prefilter.
Filter must only be replaced by qualified staff.
EC DECLARATION OF CONFORMITY
The below undersigned:
declares under its own responsibility that
Machine/Het apparaat: Ash Vacuum Cleaner
Type/Model: PRCEN003 Cenerix,
PRCEN006 Ceneplus
complies with requirements of Directives
2014/30/EU ( EMC )
2014/35/EU ( LVD )
2011/65/EU ( RoHS )
and conforms with following Standards:
EN 55014-1:2006 + A1:2009 + A2:2011
EN 61000-3-2:2014
EN 61000-3-3:2013
EN 55014-2:1997 + A1:2001 + A2:2008
EN 62233:2008
EN 60335-1:2012 + AC:2014 + A11:2014
EN 60335-2-2:2010 +A11:2012 + A1:2013
EN 50581:2012
Place and Date:
Name and signature
Alessandro
President