Woolley GW-A-GW-EACHEN eWeLink Outdoor Eye Camera Instructions

Table of Contents

eWeLINK IOT Camera
(waterproof) Woolley GW A GW EACHEN eWeLink Outdoor Eye
Camera

Please take a few minutes to read the manual before using the product.

Woolley GW A GW EACHEN eWeLink Outdoor Eye Camera -
fig1

Because the Infrared light of the outdoor waterproof camera is strong, when you install the camera, avoid placing any obstacles in front of the camera lens, otherwise monitor view will have reflective issues.
Under the condition that meets the target of the monitor field, in an indoor environment, the camera should be higher than 2.5m from the ground, in the outdoor environment, the camera should be higher than 4m from the ground.
If the camera is mounted into the wall, the white wall reflects light, and the monitor view will display the aperture. It is recommended to avoid facing the wall.
The best Angle of the camera is 20 Degree angle of depression. If the angle is to high, without the infrared light reflection, the monitor view will be too dark. If the angle is too low, the monitor view will display a white aperture.
The Camera needs to avoid direct light irradiation, reflective objects such as empty places, and water.
When installing the antenna, please do not use too much force, otherwise, the antenna will be twisted off. A part of the antenna with the needle is screwed onto the camera.
Take off the cover under the camera with a screwdriver and insert the TF card. Please be careful not to pull off the line when you take the cover and not to press the line after you put the back cover.

Please check the following before using the device:

Your phone or tablet has connected with 2.4GHz WiFi
Android phones or tablets must use a 4.0 system or a later version.
iPhone or IPad must be able to visit the App Store to download the App.
If your wireless router has a MAC address filter, please enter the router dashboard and disable MAC filtering

Woolley GW A GW EACHEN eWeLink Outdoor Eye Camera -
fig2

Search and download “eWeLink” on the app store
During the installation process, if permissions are requested, please allow
Register an account and login to eWeLink
Connect the power Find the power port of the camera, plug in and power on, and wait for the voice prompt of the camera which indicates the camera has been turned on. Press and hold the button on the camera.
After the Camera is restarted, it will prompt out the “Please use the app to connect the device” command, please open the eWeLink app, and tap + button to add a device.
Select “Sound Pairing” in the interface
After entering the “Sound pairing” interface, Read the prompt in the interface, and tap “Next” after hearing it
Make sure to enter the WiFi information correctly, tap Next to start pairing.
Wait for the pairing process to complete, follow the instructions to adjust some settings.
After adding the device successfully, it can be used.

Product instruction 2 (Manual pairing):

Connect your network cable to the camera network port.
Open the eWeLink app, tap the button + to enter the pairing device page, and tap “all devices” at the top right corner.
Enter the device list page, select “Camera
Select “eWelink IOT camera”
Select the second way “Add Manually”, tap “All set”
To adjust some settings, go to the next step.
Scan or enter DID, or select the LAN of your camera and tap confirm.

After connecting the camera, then tap the upper right corner of the app.
Enter the device setting page, select “More settings”
More settings
Enter RSTP settings to view information (Change password, select IP configuration way) The Tap and create RSTP link
After creating the RSTP link, enter the necessary information.