Woolley SA-028 Zigbee Smart Plug or Socket User Guide
- June 5, 2024
- Woolley
Table of Contents
Zigbee Smart Plug
Quick Guide V1.1
Download the eWeLink App
Add eWeLink Zigbee Bridge
Power on
After powering on, the device will enter the pairing mode defaulted during the first use and the Zigbee LED signal indicator will”flash slowly”.
The device will exit the pairing made if you do not operate it within 3 minutes. When you want to enter the pairing mode – again, long-press the button on the device for 5 seconds until the Zigbee signal light “flashes slowly” and release.
Add sub-device to the Zigbee gateways
Open eWeLink App, tap “Add” icon on the Zigbee Bridge interface, then wait to looking for and add the sub-devices.
More APP application platforms and gateway recommendations
This device supports the following gateways besides eWeLink Zigbee Bridge:
Echo Studio
Echo (4th Gen)
Echo Plus (model: ZE39KL)
2nd Gen Echo Show (model: DW84JL)
2nd Gen Echo Plus (model: L9D29R)
Samsung SmartThings hub
Gateway adding instruction:
- Refer to the gateway user manual to download the matched APP and get it paired.
- Set the device to the pairing mode.
- Add device according to the prompt of APP. Please select eWeLink when adding.
If the addition failed, move the sub-device closer to the Bridge and try again.
FCC Warning
Changes or modifications not expressly approved by the party responsible
for compliance could avoid the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two canditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Note:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>