vinamass E56 Sports Bluetooth Earphones User Guide
- June 3, 2024
- vinamass
Table of Contents
vinamass E56 Sports Bluetooth Earphones
Product parameters
- Frequency response: 20Hz-20KHz
- Operating range: =10m
- Battery voltage: 3.7 V
- Battery capacity: 60 mAh (rechargeable lithium battery)
- Charging time: =1.5 hours
- Operating time: =7 hours
- Impedance: 32 Ohm
- Sensitivity: 90:3 dB
- Speaker diameter: 10 mm
- Rated power: 3 mW
- Maximum power : 5 mW
Package Listing
- A pair of sports Bluetooth earphones
- A TYPE-C charging data cable
- A product instruction manual
- S/M/L ear caps
POWER ON/OFF
- Power on: Press and hold the button for 3 seconds, the device will start to enter Bluetooth mode automatically Tho GREEN light will flash for 1 second and there will be a “power on” tone at the same time
- Power off: Press and hold the “ ” button for 5 seconds, the red light will flash three times and then goes off, while there is a “power off” tone
Bluetooth Connection
- When the power is off, press and hold for3 seconds to enter pairing mode, “pairing” tone will sound, then red and blue lights will flash alternately.
- Turn on the phone’s Bluetooth connection, search for the device “E56”, after a successful connection, a “connected” tone will sound
- Auto connect: After the Bluetooth earphones are rebooted, 111ey will automatically connect back to the Bluetooth device that has been paired with it, and at the same time there is a tone “connected”.
Button Instructions
- “ Short press to play/pause music
- + ” Short press to raise the volume, long press for tt,e next song
- – ” Short press to lower the volume, long press for the previous song.
Incoming call operations
- Answer the calls: Short press button when the calls come in.
- Hang up the calls: Short press button during the calls
- Reject incoming calls: Press and hold the button for 1 second when incoming calls.
- To call back the last call: Double click the button
Maximum volume warning tone: “beep ”
TYPE-C: Advanced and fast charging interface.
LED status introductions
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in
a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>