HINYCOM True Wireless Stereo Earbuds Instructions
- June 5, 2024
- HINYCOM
Table of Contents
HINYCOM True Wireless Stereo Earbuds
+ iOS/Android
Follow steps 1-3 to connect to cellphones.
Please refer to the back of all relevant information of the device.
-
Tum on phone Bluetooth.
Connect to Wi-Fi and turn on Bluetooth.
-
Connect K88.
Open Case,hold near unlocked cellphone.then find K88 and connect it. -
Start Listening.
Place in ears and adjust until you hear the tone.K88 are ready to play.
Use with your other devices
After a simple one-tap setup, K88 are automatically on and always connected.
Control your music, calls, volume, directions, and more – without lifting a
finger.
Connect to other Devices
Turn off the previous phone Bluetooth.
Take K88 out from charging case,then go to Bluetooth settings and choose K88.
Controls
- Sigle tap MFB
Play/Pause a song, Answer/ End a call
—Long tap MFB
Tap 2 sec, acticate Siri
Tap 3 sec, reject incoming call.
Tap 4 sec, power on/off
Volume Button Control
Single press the “+” button to volume+
Single press the “-” button to volume-
Long press “+” button to skip back
Long press “-” button to skip forward
Check the case status
Charging case the number will flash from 1 2 3 to 100 earbuds from o9ne bar to four bar
Charging way
Wireless charging type-C fast charging.
Charge.
K88 charge while in the case.
More than 600mAh
charging case which is mini, lightweight and portable.
Upto 100hrs
of listening time with multiple addtional charges in the case.
Around 10 hrs
of listing time on one charge of single buds.
FCC Cautions
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be u sed in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>