EVANNEX Y Mud Flaps Instruction Manual
- June 5, 2024
- EVANNEX
Table of Contents
EVANNEX Y Mud Flaps
Please read these Installation Instructions BEFORE you install EVANNEX Mud
Flaps. Detailed video installation instructions can be found
atevannex.com.
EVANNEX Mud Flaps have been designed to protect the lower body panels of your
Model 3 or Model Y from road debris. Installation of EVANNEX Mud Flaps is a
relatively straightforward DIY project. However, if you’re uncomfortable with
the installation for any reason, we recommend that you contact a professional
installer and have them do the installation for you.
INSTALLATION
Tools required: A small, flat head screwdriver, a 10mm socket and socket wrench, a cleaning cloth
Installing Front Mud Flaps
- Step 1. Turn your wheel and tire so that you’ll be able to access the appropriate wheel well area.
- Step 2. Clean the area around the OEM fasteners (see photo) in the rear area of the wheel well.
- Step 3. Using the small flat head screwdriver, pop the center push screw of both of the OEM fasteners on the inside of the wheel well. Using the flathead, raise the push screw and pop it out along with the expansion fastener. Don’t become concerned if the push screw or the fastener breaks. You are provided with replacement push screws and fasteners (see photo).
- Step 4. Snap the mud flap into place aligning the holes in the mud flap with the OEM holes in the wheel well.
- Step 5. Push the expansion fastener clip and push the screw provided into the OEM hole in the wheel well. There are two (2) holes in the front wheel well.
- Step 6. Repeat steps 1 through 5 for the other front wheel well.
**Installing Rear Mud Flaps
**
-
Step 1. Clean the area around the OEM fasteners in the rear area of the wheel well.
-
Step 2. Using the small flat head screwdriver, pop the center push screw of the single OEM fastener on the inside of the wheel well. Using the flathead, raise the push screw and pop it out along with the expansion fastener. Don’t become concerned if the push screw or the fastener breaks. You are provided with replacement push screws and fasteners.
-
Step 3a (for Model 3): Using the 10mm socket and socket wrench, remove the 10 mm bolt on the bottom of the fender near the edge of the wheel.
Step 3b (for Model Y): Do NOT remove the 10 mm bolt on the bottom of the fender. The 10 mm mounting tab should be placed on top of the OEM bolt. Push down on the tab to seat it in place. -
Step 4. Snap the mud flap into place aligning the holes in the mud flap with the OEM hole in the wheel well (see photo).
-
Step 5. Push the expansion fastener clip and push screw provided into the OEM hole in the wheel well. There is one (1) hole in the rear wheel well.
-
Step 6. For Model 3 only, place the 10mm bolt through the hole on the bottom of the Mud Flap and then using the 10mm socket and socket wrench, replace the
10 mm bolt on the bottom of the fender near the edge of the wheel well. -
Step 7. Repeat steps 1 though 6 for the other rear wheel well.
EVANNEX® ••• Tesla Aftermarket Accessories •••
evannex.com
Disclaimer: EVANNEX is not responsible for any vehicle damage caused during
the installation or use of this product. Any costs associated with any vehicle
damage are the sole responsibility of the purchaser.