HYPER TOY HRC2013-R Drift King Car Instruction Manual

HYPER TOY HRC2013-R Drift King Car

Notice:
If the car is in the raised state (as shown in the figure 1 ), please do not twist the front or rear of the car. Open the battery cover to connect the battery, then turn on the power switch, the car will automatically twist to the flat state (as shown in the figure 2 ), and then it can operate normally!

Batteries and Instructions for charging

• The remote control unit is equipped with two 1.5V AA non-rechargeable batteries (Battery need additional purchase).

  •  Loosen the screws on the battery door with cross screwdrivers.
    (Phillips screwdriver need additional purchase)

  •  Load the new 1.5V AA batteries corresponding the”+” and”-” in the battery case to the “+” and “-” of the batteries.

  •  Cover up the battery cover, and tighten the screws.

•  Charging mode of USB cable

  •  Take out the rechargeable battery from the product as shown in the diagram. (Phillips screwdriver need additional purchase)

  •  Plug the USB into the computer’s USB interface, and then plug the lithium battery into the charge port of the USB, when the red indicator light for charging in the USB will be long-on. A full charge will take about 90 minutes. After a full charge, the red indicator light will be off, and the product will be used 5 minutes later. Overcharging may damage the batteries, cause burnings or catch a fire.
    Notice:
    When the product is idle, please push its power switch to “OFF”, and take out the batteries in case the service life of the rechargeable batteries is affected.

  •  Load the battery pack in the battery case by corresponding to the correct electrodes, and cover up the battery cover. (Phillips screwdriver need additional purchase)

Battery Warning

•  Do not mix alkaline, standard(carbon zicn), rechargeable(nickel hydride) batteries.
•  Do not mix old and new batteries.
•  Non-rechargeable batteries should not be recharged.
•  Rechargeable batteries should be removed from the appliance before being charged.
•  Rechargeable batteries should be charged under adult supervision only.
•  Exhausted batteries should be removed.
• The supply terminals should not be short-circuited.
•  Only batteries of the same or equivalent type are recommended to be used.
•  Batteries should be inserted with the correct polarity.

Rechargeable batteries are to be removed from the toy before being charged; The packaging or instruction shall include a statement that the charger to be used with the sample should be regularly examined for potential hazard, such as damage to the cable or cord, plug, enclosure of other parts and that in the event of such damage, the sample must not be used until that damage had been properly removed.

Description of functions of remote controller

Demonstration and description of functions

Turn on the power: Pull the power switch of the remote control car to the “ON” position, press the”
indicator flash, then the power will be turned on. If the operation indicator of the remote controller is on continuously, then the frequency matching succeeds. Long press the power switch button ” power switch of the remote controller, making the power “of the remote controller to turn off the pOwer and also the indicator light of the controller.
Remote control distance: About 20-30m.
Using time: Up to 16 minutes about under a full charging state.

NOTE:
When the remote controller fails to control the remote control car, power off the remote controller first, then power off the remote control car, and then power on the remote controller and the remote control car again. If the indicator light of the remote controller is on continuously, then frequency matching succeeds.

MOVE FORWARD/ MOVE BACKWARD
Push up/pull back the left control lever to move the remote contorl car forward/backward; push up/pull back the left control lever continuously, then remote control car will move forward/backward continuously.

DRIFT LEFT
Push the right control lever to the left, then remote control car will drift to the left; push the right control lever to the left continuously, then the remote control car will drift to the left continuously.

DRIFT RIGHT
Push the right control lever to the right, then remote control car will drift to the right; push the right control lever to the right continuously, then the remote control car will drift to the right continuously.

LEFT ROTATION
Push the right control lever to the left, then remote control car will rotate in its original place in the counter-clockwise direction, push the right control lever to the left continuously, then the remote control car will rotate in its original place in the counter-clockwise direction continuously.

RIGHT ROTATION
Push the right control lever to the right, then the remote control car will rotate in its original place in the clockwise direction; push the right control lever to the right continuously, then the remote control car will rotate in its original place in the clockwise direction continuously.

LEFT FORWARD TURN
Push the left control lever up and the right control lever to the left, and then the remote control car will move forward and to its left.

RIGHT FORWARD TURN
Push the left control level up and the right control level to the right, and then the remote control vehicle will move forward and to its right.

LEFT BACKWARD TURN
Pull the left control lever down and the right control lever to the left, and then the remote control car will move backward and to its left.

RIGHT BACKWARD TURN
Pull the left control lever down and the right control lever to the right, and then the remote control car will move backward and to its right.

Body twisting distortion
Press the” B “button, the remote control car body rises and becomes the off- road vehicle mode. Press the “(B)” (B) button again to lower the body of the remote control and resume the sports car mode.

Dance
When the” C”key is pressed once, music will be played and at the same time the remote control car will start to automatically dance; when the “(C)” key is pressed again, the next dancee music is switched to automatically.

Add clean water

1.  Remove the water plug on the top of the remote control car.
2.  Pour clean water into the water hole at the top of the remote control car with a kettle.
3.  Put back the water plug.

Notice:

1.  The water injected into the car should be clean without impurity.
2.  The injected water should not be too full in order to prevent the circuit board from immersing into the overflowing water, resulting in short circuit.

Spray
Press the ” D ” button to control the car to spray from the rear spray jet (as shown on the right).

WARNING
There are small parts inside possibly causing a choking hazard, so the product isn’t suitable for children 3 years old and below. When the product is being used, an adult must be on the scene for guardianship and guidance. These instructions have important information and thus shouldn’t be discarded randomly. They should be kept properly for future inquiry.

 Solutions to problems

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>